Pioneer DVR-630H-S, DVR-530H-S manual Additional information

Additional information 14

Problem	Remedy
The picture is distorted	• Change the Input Line System setting (page 98). (You can also change it by
	pressing the STOP button and OPEN/CLOSE on the front panel
	simultaneously with the recorder stopped.)
Screen is stretched vertically or hori-	• Make sure that the TV Screen Size setting (page 96) is correct for the kind of TV
zontally	you have (see also page 100).
	• If you have a widescreen TV, check its aspect ratio settings.
	• This recorder’s input switches into wide mode automatically according to the
	input signal. When the unit connected is not compatible with VIDEO ID-1
	(widescreen signalling), set the connected component to output 4:3 aspect ratio
	(standard) video.
Can’t play a disc recorded using this	• If the disc was recorded in Video mode, make sure that it’s finalized (page 48).
recorder on another player	•Some players will not play recordable DVD discs, even when recorded in Video
	mode and finalized.
	• If the disc was recorded in VR mode, the other player must be specifically RW
	compatible in order to play it (page 9).
	• Discs recorded with copy-once material cannot be played on non-CPRM
	compatible players (page 36).
During playback the picture is dark	• When a copy-protected disc is played via a VCR, the picture will not display
or distorted	correctly. Connect the recorder directly to your TV.
Can’t control your TV using this	• If there is more than one code listed for your make of TV, try each one in turn
remote control	(page 99).
	• It is possible that none of the codes listed will work with your particular model of
	TV, even if the maker appears in the remote control code list.
Can’t record or does not record suc-	• Check that there is some remaining blank space on the DVD/HDD.
cessfully	• For a Video mode disc, check that the disc isn’t already finalized.
	• The HDD may contain up to 999 titles; one DVD disc 99 (Original) titles and 999
	chapters (VR mode), or 99 chapters (Video mode). Check that these limits have not
	been reached.
	• Check that the source you are trying to record is not copy protected.
	• For a VR formatted disc, check that the disc isn’t locked (page 87).
	• Check that you are recording with the same TV system (PAL, NTSC, etc.) as the
	disc has already been recorded in. All recordings on a disc must be in the same TV
	system.
	When recording to the HDD, it is also necessary to set the Input Line System
	setting to match what you want to record (page 98).
	• The power may have failed during recording.
Timer program doesn’t record suc-	• When setting the recording channel, make sure you set the recorder’s built-in TV
cessfully	tuner, not the TV’s built-in tuner.
	• When recording to a Video mode disc, programs that are copy-once protected
	cannot be recorded. Use a VR mode formatted disc for copy-once material
	(page 36).
	• Two timer programs may have overlapped, in which case only the earlier one will
	record completely.
	• The power may have failed during recording.
	• Check that the recorder’s TV system (PAL, NTSC, etc.) settings are the same as
	the channel set for recording.

After briefly unplugging or after a power failure the front panel dis- play shows ‘--:--’

•A backup battery inside the recorder keeps the clock and other settings from being reset when there is no power to the recorder. This battery should last approximately five years from factory shipping.

Reset the clock and other recorder settings to use the recorder again. To have the battery replaced, contact your dealer or a Pioneer Service Center.

103

En