Pioneer DVR-630H-S, DVR-530H-S manual Playing CDs and WMA/MP3 discs, Playing Video CD/Super VCDs

Page 31

Getting started

04

Playing CDs and WMA/MP3 discs

The table below shows the basic playback controls for audio CDs1, and WMA/MP3 files.

PLAY Press to start playback.

STOP Press to stop playback.

PAUSE Pauses playback, or restarts playback

when paused.

REV SCAN FWD SCAN Press to start scanning. Press again to increase the scanning speed. (There are two scan speeds; the current scan speed is shown on-screen.)

PREV NEXT Press to skip to previous/next track (or folder for WMA/MP3 disc). (During play- back you can also use the front panel +/– buttons.)

During playback, enter a track number then press ENTER to skip directly to that track.

Press CLEAR to clear a number entry and

CLEAR

CLEAR

start again.

ENTER

 

Playing Video CD/Super VCDs

The table below shows the basic playback controls for Video CD/Super VCDs.

Some discs feature Playback Control (PBC for short) menus. These discs show PBC in the display when you load them and display a menu on-screen from where you

can select what to watch.2

PLAY Press to start playback.

Video CD only: If RESUME is displayed on- screen, playback starts from the place last stopped.

STOP Press to stop playback.

Video CD only: You can resume playback from the same point by pressing PLAY. (Press STOP again to cancel the resume function.)

PAUSE Pauses playback, or restarts playback

when paused.

REV SCAN FWD SCAN Press to start scanning. Press repeatedly to increase the scanning speed.

 

 

 

 

Press to skip to previous/next track.

 

 

PREV

NEXT

 

 

 

 

When a PBC menu is displayed, press to

 

 

 

 

 

 

 

 

display the previous/next page. (During

 

 

 

 

playback you can also use the front panel

 

 

 

 

+/– buttons.)

 

 

 

 

 

 

 

 

 

During playback, enter a track number

 

 

 

 

 

 

 

 

then press ENTER to skip directly to that

 

 

 

 

track.

 

 

 

CLEAR

Press CLEAR to clear a number entry and

 

 

 

CLEAR

start again.

 

 

 

 

While a PBC menu screen is displayed,

 

 

 

 

 

 

 

 

 

 

 

ENTER

use to select numbered menu items.

BACK CM SKIP Video CD only: Each press skips backward/ forward progressively up to a maximum of

ten minutes forward or three minutes back. Note that this function doesn’t work when playing in PBC mode.

STEP/SLOW During playback, press to start slow- motion playback. Press repeatedly to

change the playback speed (forward only). While paused, press to advance a single frame (forward only).

RETURN Press to display the disc menu of a Video

CD/Super VCD playing in PBC mode.

Note

1.If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with a digital connection. Noise will be output through the analog outputs. Also make sure that STEREO is selected using the AUDIO button (see Switching audio channels on page 58).

2.When playing in PBC mode, some playback features, such as search, repeat and program play are not available. You can play a PBC Video

CD/Super VCD in non-PBC mode by pressing

to start playback instead of PLAY.

31

En

Page 30 Page 32
Image 31
Page 30 Page 32
Contents DVR-630H-SDVR-530H-S Risk of Electric Shock Do not Open Ventilation Caution Operating EnvironmentContents Additional information Disc Setup menuVideo/Audio Adjust menu Initial Setup menuBefore you start FeaturesBefore you start Chapter Before you start Using the remote control Putting the batteries in the remote controlBefore you start What’s in the box Compressed audio compatibility General disc compatibilityDVD-R/RW compatibility CD-R/RW compatibilityJpeg file compatibility WMA Windows Media Audio compatibilityPC-created disc compatibility Optimizing HDD performance About the internal hard disk driveFront panel connections Connecting upConnecting up Chapter Rear panel connectionsConnecting up Easy connections Connecting using an S-video output Connecting up Using other types of video outputConnecting using the component video output Connect RF antenna cables as shown This enables you to watch and record TV channelsThis enables you to watch the output from this recorder This enables you to record scrambled TV channelsThis enables you to watch discs This enables you to listen to multichannel surround sound.1 Connecting up Connecting to an AV amplifier or receiverConnecting up Connecting other AV sources Plugging Connecting up Connecting a USB deviceJpeg file storage devices Controls and displays Chapter Controls and displaysFront panel Return Controls and displays Remote controlControls and displays EP / SEP Controls and displays DisplayNtsc LP / SLPGetting started Switching on and setting upGetting started Chapter Enter Getting startedIs your TV compatible with progressive scan video? Other settings you can makeSelecting the hard disk or DVD for playback and recording Select the TV screen type, ‘Wide 169’ or ‘Standard 43’Press REC to start recording When you want to stop recording, pressGetting started Making your first recording Playing back your recordingNicam Getting started Using the built-in TV tunerChanging TV channels Changing audio channelsPress OPEN/CLOSE to open the disc tray Load a disc Press STANDBY/ON to switch onGetting started Basic playback Press HDD to playback from the HDD, or DVD to play a DVDPlaying from the HDD Playing DVD discsPlaying Video CD/Super VCDs Playing CDs and WMA/MP3 discsHome menu options Getting started Using the Home MenuDisplaying disc information on- screen Home MenuStop display HDD and removable disc activity displayPlay display Recording display Total running time of title Angle indicatorCopy protected material ! / PureCinema indicator # Recording modeAbout DVD recording HDD Video mode compatibilityRecording Recording ChapterRecorded audio Recording Recording time and picture qualityRestrictions on video recording Recording equipment and copyright Setting the picture quality/recording timeRecording Basic recording from the TVUse the Audio button to select the audio channel to record Setting a timer recordingTo stop the recording, press Stop REC Current time Recording start time Easy Timer RecordingPress Enter to set the start time Press Enter to set the end time Timer recording using the G-Code programming systemAfter making the settings, select ‘Enter’ and press Enter Confirm that the settings are correctSetting a manual timer recording Code programming with the power offTo exit the timer recording screen, press Home Menu Tip Enter the timer recording settingsSkipping a regular timer program Extending a timer recording in progressEditing a timer program Deleting a timer programWhat happens when two or more timer programs overlap? Timer recording FAQCanceling and stopping a timer recording in progress You can’t enter a timer program if the clock isn’t setRecording Simultaneous recording See Connecting up for connection optionsPlayback Component Automatic recording from a satellite tuner Set up the recorderPress REC when you’re ready to start recording See Audio In Settings on page 93 for more on these settingsPress Enter Also, set the camcorder to VTR modeRecording Recording from a DV camcorder UseThere’s a picture, but no sound Playing your recordings on other DVD playersFinalizing a disc Can’t get my DV camcorder to work with the recorderIt takes about 30 seconds to initialize the disc Recorder’s settingPress Home Menu and select ‘Disc Setup’ Select ‘Initialize’ Initializing a recordable DVD discNavigating discs and the HDD PlaybackPlayback Chapter IntroductionPlayback Using the Disc Navigator to browse the contents of a discPress Using the Disc Navigator with playback-only discsStyle Select four or eight titles per screen view Genre Display all genres or just a selected genreScan Playback Scanning discsPlaying in slow motion Slow 1/16 Slow 1/8 Slow 1/2Playback Frame advance/frame reverse Play Mode menuSearch Mode Play ModeRepeat play RepeatPlayed over and over.1 Repeat to build up a program list Program playClear Switching DVD soundtracksDisplaying and switching subtitles Other Program play functionsTo switch the camera angle, press Angle Playback Switching audio channelsSwitching camera angles To display/switch the audio channel, press Audio repeatedlyCopyright Copying and back-upCopying and back-up Chapter One Touch CopyCopying from HDD to DVD Using Copy ListsCanceling One Touch Copy Copying and back-upIf you select Use Existing Copy List, skip to below Select VR mode or Video mode for the copyPress to display the command menu panel Command Menu panel Select ‘HDD DVD’Select ‘Start Copy’ to start copying Select ‘Next’ to move on to the Title Edit screenErase Copying from DVD to HDDTitle Name Highlight the title you want to move and press Erase SectionMove Select the type of editChapter Edit PreviewDivide CombineSet Thumbnail Recording ModeBilingual Using disc back-upOption Copying and back-up To exit the Disc Navigator, press Home Menu EditingEditing Chapter Disc Navigator screenHDD genres Editing Command menu panel optionsVideo mode VR mode Original Play List Editing accuracySelect a title to add to the Play List Select ‘Create’ from the command menu panelEditing PlayKey Characters Using the remote key shortcuts to input a nameUsing a USB keyboard to enter a name Key FunctionSelect ‘Exit’ to return to the Edit screen Select ‘Edit’ ‘Set Thumbnail’ from the command menu panelOK? Select ‘Exit’ to get back to the main Disc Navigator screen Use this command to assign a genre to a titleSet Genre LockDefinable genre names, then press Enter Select ‘Genre Name’ from the command menu panelSelect ‘Edit’ ‘Combine’ from the command menu panel Genre NameUndo Multi-ModePress DVD Load the CD you want to copy to the HDD Using the JukeboxUsing the Jukebox Chapter Copying CDs to the HDDEditing Jukebox albums Using the Jukebox Playing music from the JukeboxSelecting a track from an album to play Genre Using the JukeboxChanging the album view Sort orderCurrently selected thumbnail Photo ViewerPhoto Viewer Chapter Locating Jpeg picture filesZooming the image Photo Viewer Playing a slideshowImporting files to the HDD Reloading files from a disc or USB deviceCopying files to a DVD-R/RW Photo ViewerSelecting multiple files or folders Erasing Editing files on the HDDCopying selected files to a DVD-R/RW Creating a new folderSelect ‘Erase’ or ‘Erase Folder’ NamingCopying Locking/UnlockingSelect ‘Print’ from the menu Once printing has started, you can cancel by pressing EnterPhoto Viewer Printing files Select the files you want to printInput Disc Name Disc Setup menuDisc Setup menu Chapter Basic settingsInitialize HDD Disc Setup menu Initialize settingsFinalize settings1 Optimize HDDChoosing a preset Video/Audio Adjust menuVideo/Audio Adjust menu Chapter Setting the picture quality for TV and external inputsSetting the picture quality for disc playback Video/Audio Adjust menuSelect the picture quality setting you want to adjust ‘Max’ Audio DRCSetting Options Explanation Initial Setup menuInitial Setup menu Chapter Using the Initial Setup menuInitial Setup menu Mpeg PCM MpegAuto Language Language Settings OSD Language EnglishAudio Language English OtherVideo Mode On DVD-RW Auto Init VR ModeVideo Mode Video Mode OffUSB Additional information about component video output Additional information about the TV system settingsSelecting other languages for language options Additional information Resetting the recorderSetting up the remote to control your Using the TV remote control buttonsWhen viewing on a widescreen TV or monitor When viewing on a standard TV or monitorAdditional information Screen sizes and disc formats SEP Additional information Minimum copying timesSLP Problem Remedy Additional information TroubleshootingGeneral Additional information Device connected to the USB port isn’t recognized ProblemCan’t use One Touch Copy HDD to DVD Can’t use One Touch Copy DVD to HDDHow do I make a high-quality copy? Additional information Frequently asked questionsDV-related messages Additional information About DVVR mode DVD Video mode DVD Resolution Level Video mode On HDDAdditional information Manual recording modes Country/Area, Country/Area code, Code letter Additional information Language code listCountry/Area code list Language Language code letter, Language codeMessage Explanation/Action Message Storing discs Cleaning the pickup lensAdditional information Handling discs CondensationGlossary Additional information Hints on installationMoving the recorder Exif Exchangeable Image File DRM Digital Rights Management Mpeg audioMpeg video Dynamic rangeSpecifications Input/Output Supplied accessoriesTimer TunerFrom HDD to DVD 60, 60-62,101 high-speed59, 66 Connecting 12, 18 error messages 106 recording fromLanguage audio 57, 95 code list 108 DVD menu IndexUSB 12, 19, 72, 81, 82, 86, 104 NtscVRB1383-A Pioneer Corporation
Top Page Image Contents