Pioneer DVR-530H-S, DVR-630H-S manual Timer recording using the G-Code programming system

05Recording

5 Use the to move the cursor to the recording end time on the grid.

Recording start time

Recording end time

Easy Timer Recording
11:00	12:00	13:00	14:00		15:00	16:00	17:00
1/01
2/01
3/01
SAT	1/01		11:45		–	13:45
CHANNEL +/–	Pr 7	REC MODE		SP		HDD/DVD	HDD

As you move the cursor around the grid, an arrow stretches from the start time to the current cursor position, representing the length of the recording. A recording of up to six hours can be set.

6Press ENTER to set the end time.

7Select ‘Yes’ to set the timer recording and exit, or ‘No’ to go back to the timer recording screen.

•You can check the timer recording details you just set from the main timer recording screen (see Setting a manual timer recording on page 41).

Timer recording using the G-Code™ programming system

This system makes programming timer recordings very simple. Most TV guides publish G-Code programming numbers with their program details. If you want to make a timer recording of a program, you just input the corresponding code. The date, start, stop and channel settings are made automatically. All you have to do is tell the recorder the recording mode, and whether it’s a once-only recording or a regular recording.

Note that if the country setting is incorrect (set in the Setup Navigator), timer recordings made using the G- Code programming system may not work as expected.

40

HDDDVD

CH

G-CODE +	CLEAR
	CLEAR

ENTER

HOME

MENU

REC MODE

1Press ‘G-Code’ to display the G-Code program screen.

You can also access this screen from the Home Menu (press HOME MENU, select Timer Recording, then G-Code).

G-Code#

1 2 3

4 5 6

7 8 9 Cancel

0 Clear Enter

•Use the number buttons to enter the G-Code programming number. (To clear the last digit entered, press CLEAR.)

• You can also use the	buttons to select
digits from the on-screen display.

2After making the settings, select ‘Enter’ and press ENTER.

The timer recording screen appears with the timer program you just set.

3Confirm that the settings are correct.

If the channel number isn't displayed, use the

buttons to highlight CH, then use the buttons to set the correct channel number.

•If the channel number is set, but incorrectly, set up the guide channel (see G-Code CH Setting on page 93).

En