Pioneer Guide for Setting Up Volume Levels for VSX-D711 and VSX-D811S Receivers

06Setting up the receiver

Setting the relative volume level of each channel

•Default setting: 0db

For best surround sound playback, you should set the relative channel levels from the main listening position. You can set seperate levels for each surround mode.

1Press RCV.

2Press TEST TONE to output the test tone.

The test tone is output in the following order (depending on the speaker setting):

FL C FR

SR

SW SL SB*

*VSX-D811S only

If you don’t hear a test tone from one of your speakers, please refer to Speaker setting on page 39 to make sure you have correctly specified your speaker setup.

3Press MASTER VOLUME +/– to adjust the volume to an appropriate level.

4Use LEVEL +/- to adjust the speaker levels in turn.

You should hear the test tone at the same volume from each speaker when seated in the main listening position. The channel level range is ± 10 dB.

5When you’re done, press TEST TONE to turn off the test tone.

The speaker volume can be adjusted without outputting the test tone by pressing CH SELECT and then using LEVEL +/–.

44

En

XRB3013A.38.44 44

SOURCE				RECEIVER
DVD		TV	VCR		CD-R
		MULTI CONTROL
RCV		CD	TUN		TVC
1		2			3
TEST TONE		INPUT ATT		FL DIMMER
4		5			6
CH SELECT			LEVEL
7		8			9
+10			EFFECT		DISPLAY
		0			DISC
				ENTER
DTV INFO	MPX/RETURN		D.ACCESS		T.EDIT/GUIDE
¶		7	3		8
BAND		CLASS	DTV ON/OFF		DTV MENU
1		¡	4		¢
TOP MENU		AUDIO	SUB TITLE		ANGLE
REMOTE SETUP	STANDARD		ADV.SURR.		STEREO
INPUT SEL.	SIGNAL SEL		MIDNIGHT/		MUTE
			LOUDNESS
		RECEIVER CONTROL
		TUNE
ST		SETUP			ST
		ENTER
		TUNE
		CHANNEL
		MENU
TV VOL		TV INPUT		MASTER VOLUME

TV

TV CONTROL

AV PRE-PROGRAMMED

REMOTE CONTROL UNIT

•Test tone is only output in Standard modes.

•Since the subwoofer transmits an ultra- low frequency its sound may seem quieter than it actually is.

01.12.12, 4:46 PM