Installation and Connections
Connection of G ON SYNC analog RGB source
Make G ON SYNC connections for a component with output that has the synchronization signal layered on top of the green signal.
When connecting to INPUT1
|
|
|
| INPUT1 | OUTPUT |
|
ANALOG RGB |
|
| ||||
(ANALOG RGB) |
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
On screen setup is necessary after connection. Please see pages 18 and 19.
When connecting to INPUT2
(ON SYNC) |
| INPUT2 | (H/V SYNC) |
|
G | B | R | HD | VD |
75Ω Ô2.2kΩ
On screen setup is necessary after connection. Please see pages 18 and 19.
Note
When making G ON SYNC connections, do not make any connections to the VD or HD terminals. If connections are made, the picture may be not displayed normally.
10
Connection of composite SYNC analog RGB
source
Make composite SYNC connections for a component with output that has the vertical synchronization signal layered on top of the horizontal synchronization signal.
When connecting to INPUT1
|
|
|
| INPUT1 | OUTPUT |
|
ANALOG RGB |
|
| ||||
(ANALOG RGB) |
| |||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
When connecting to INPUT2
(ON SYNC) |
| INPUT2 | (H/V SYNC) |
|
G | B | R | HD | VD |
75Ω Ô2.Ω2 k
When using INPUT2, set the impedance selector switch to match the output impedance of the connected component’s synchronization signal.
When the output impedance of the component’s synchronization signal is below 75 Ω , set this switch to the 75 Ω position.
Note
When making composite SYNC connections, do not connect anything to the VD terminal. If connected to, the picture may not be displayed properly.