Sennheiser FT-902S15, FT-906B20, FT-905A, FT-902S35, FT-906A20 Remote monitoring Transmitter battery

Page 32

Remote monitoring of

4.1.7

transmitter battery

 

DIVERSITY

A B

MENU

Y

N

SET

ESC

MANIPULATION

Choose the option to indicate the condition of the transmitter battery (see ch. 4.1.1).

DepressSET

to select the display mode for the indication of the battery condition.

NOTA BENE

This function is only operative if SK 50 UHF, SK 250 UHF or SKM 5000 UHF transmitters are used.

DepressESC

to return to the previous level.

This key also serves to stop data entry in case of errors.

FUNCTION

 

DISPLAY (RX)

The EM 1046 RX receiver module distinguishes between two types of power supply: the transmitters can be powered by batteries or rechargeable batteries.

If primary cells are used, the display indicates the remaining capacity in three steps. A 5-step display is used for rechargeable batteries.

If you connect transmitters other than SK 50 UHF, SK 250 UHF or SKM 5000 UHF, the display indicates

CONDITION OF PRIMARY CELLS:

Capacity of 100 %

Capacity of about 70 %

Capacity of about 30 %, the display starts blinking.

Attention !

Replace the transmitter batteries.

The remaining capacity only suffices for about half an hour!

EM 203, Publ. 10/94 engl

32

Page 31 Page 33
Image 32
Page 31 Page 33
Contents Instruction for USE LED indicators Monitor headphones Introduction Important InformationTechnical overview Computer control Diversity Dynamics of the AF Input Signal HiDyn plusBlock diagram EM Possible transmitter Receiver combinations EM 203 receiver SK 2012 TV HiDyn plus SKM 4031 TV-HiDyn plus EM 1046/2.2 SK 50 UHF / SK 250 UHF SKM EM 203 receiver SER 20 transceiver Putting the EM 203 receiver To work Mains connection Start-up procedure Operating indications Nota BeneAvailable modules EM 1046 RX Receiver module Monitor EM 1046 RX receiver module Operating Elements on the EM 1046 RX Module Adjustment Receiver operation remains unaffectedManipulation Function Display RX Use keys Additional frequencies can be selected, if Subsequently RF signal level/deviation/batery condition From page 24, CH Nota Bene From page 26, CH From page 27, CH Display4.1.5 Text/frequency/battery condition Display indicates again To stop storage System configurations Identification data EM 1046-U-HRemote monitoring Transmitter battery Manipulation Function SET SET ESC LED indicators Monitor headphones Operating ElementsLED indicators Nota Bene Technical data Sennheiser Electronic KG
Top Page Image Contents