Connection between the computer and plasma display
Connection with computer
USB
Plasma Display (Rear view)
Pen
OFF ON
USB connector
USB cable
Computer
Touch Panel
∗Check that the USB power supply of the computer being used is rated at 500 mA.
(1)Connect the plasma display and computer with the VGA cable.
(2)Turn on power in the following sequence: 1: Plasma Display, 2: Computer.
(3)Switch the plasma display input signal to the computer.
(4)After the computer OS starts up, connect the touch panel and computer with the USB cable.
(5)Insert the
Notes:
•After the computer OS has finished starting up, connect the USB cable.
•If you connect using a USB hub, you must supply power to the USB hub.
•For details on USB driver software setup, see “USB driver setup.” (See below)
•After USB driver setup, you must set up the touch panel driver software. (See page 21)
•If the infrared transmissive part of the screen is accidentally obstructed (such as by your finger) while connecting the USB, an element defect will be detected. If you use the system in that state, it may respond poorly to touch. If this happens, remove the USB cable and insert it again. You do not need to restart the computer.
Installation of the USB driver |
|
In case of Windows 98 / Second Edition (SE) | page 12 |
In case of Windows Millennium Edition (ME) | page 14 |
In case of Windows 2000 | page 16 |
In case of Windows XP | page 18 |
10