Attachment of the touch panel to the plasma display
3 Attach mounting bracket [B]
Tentatively fasten a fixing screw in the left and right speaker mounting screw holes on the rear of the touch panel and plasma display to attach the mounting bracket [B].
For the 42", you must attach mounting brackets to both sides, and for the 50" you must attach a mounting bracket to only the right side (looking from the back).
Mounting bracket [B]
Screw [B]
For | For | |
Attach mounting bracket [B] | ||
| ||
4 Lower the tentatively fastened mounting bracket. |
|
Loosen the tentatively fastened bracket mounting screws, and lower the mounting bracket.
5 | Fasten mounting brackets. [A] | 6 | Fasten the touch panel. |
Fasten mounting brackets [A] to the display.
Fasten the touch panel to the display.
After hand tightening the bracket mounting screws, tighten them further using a flathead screwdriver. Fasten so there is no large gap between the touch panel and the display front surface.
Be careful not to overtighten the mounting bracket screws as this will cause warping.
7 Fasten mounting brackets. [B]
Secure the mounting bracket [B] by using a Phillips head screwdriver to tighten the tentatively fastened screw.
9