Panasonic TC-P60GT30 First Time Setup, Turn the TV On with the Power button, Identifying Controls

First Time Setup

The first time setup screen is displayed only when the TV is turned on for the first time after the power cord is inserted into a wall outlet and when “Auto power on” (p. 53) is set to “No”.

Turn the TV On with the POWER button

(TV)(Remote)

or

or

Configure your viewing mode

Select your language

Language / Idioma / Langue			Step 1 of 7 / Paso 1 de 7 / Étape 1 de 7
Select your language
Seleccione su idioma							select
Sélection de la langue
English
		Español		Français
							OK
Select	OK
Selección
Sélection
Select your country
Country						Step 2 of 7
Select the country where this TV is being used.							select
	U.S.A.
			Canada		Other
							OK
Select	OK
	RETURN

Select your viewing mode (Be sure to select “Home use”)

Set viewing mode			Step 3 of 7
	Select your viewing environment		select
	Home use	Store Demonstration
			OK
Select	OK
	RETURN

●Please confirm your selection (Home Use) before pressing OK button.

■If you select “Store Demonstration” by mistake in , confirmation screen will be displayed.

You are selecting the store demonstration mode.
Yes	No	select

If you select “Yes”, the picture mode will regularly reset

to “Vivid” and a Picture Refresh message will be displayed on the

screen. OK

●Select “No” and return to previous screen

●If you select “Yes”, Screen enters the store demonstration mode.

To display the “Set viewing mode” screen again as shown above and select “Home Use”, do one of the following:

•Press and hold down the front POWER button for at least five seconds.

•Unplug power cord for 30 seconds and plug it again.

Getting started First Time Setup

Identifying Controls

Note

●If you use any other step other than then turn the TV off, or if you used the EXIT button to quit before completing the settings, the next time you turn the TV on, “First time setup” will not be automatically displayed.

•The settings up to that point are saved.

•You can start “First time setup”. (p. 53)

●Language, ANT/Cable setup, Input labels, and Clock can also be changed

in the Settings Menu. (p. 53) 15