Off
Off
Off
Off
PC
RGB
Input labels for Slot1, Slot2, Slot3 and mini D-sub:
[Slot1 Input] INPUT1 / VIDEO1 / COMPONENT1 / RGB1 / DIGITAL1 / PC1 / DVD1 / CATV1 / VCR1 / STB1
[Slot2 Input] INPUT2 / VIDEO2 / COMPONENT2 / RGB2 / DIGITAL2 / PC2 / DVD2 / CATV2 / VCR2 / STB2
[Slot3 Input] INPUT3 / VIDEO3 / COMPONENT3 / RGB3 / PC3 / DVD3 / CATV3 / VCR3 / STB3 [PC (Mini D-sub) input] PC / COMPONENT / RGB / DVD / STB
When TY-FB9BD (optional BNC Dual Video Terminal Board) is used, an “A” or “B” is added at the end of each input label, depending on the input selected (see below).
Note:
While selecting an Input signal through Optional Terminal Board connected to Slot1, Slot2 and Slot3, the Input label will depend on each Optional Terminal Board.
English (UK)
Press to change the Input label.
Press to select Input label.
Customizing the Input labels
This function can change the label of the Input signal to be displayed.
Select the input signal which you would like to change its label before customizing the Input labels. (see page 13, 15)
Note:
“Power management” and “Auto power off” are effective during normal viewing (one picture screen) only.
Press to exit from Setup.
OSD Language
Auto power off
Standby save
Power management
Power save
Input label
Signal
Component/RGB-in select
Setup
1
2
3
• Auto power off:
• Power save:
• Standby save:
Reduces power consumption
When this function is turned On, luminous level of the Plasma Display is suppressed, so power consumption is reduced.
When this function is turned On, power consumption of the microcomputer is reduced during power supply standby (see page 12, 14-15), so standby power of the set is reduced.
•Power management: The unit power supply is turned On or Off depending on whether or not there is a signal during PC input mode.
This function is enabled when it is turned On. (Only during input from PC (Mini D-sub) terminal)
Equipment power supply is turned Off when there is no signal.
When this is set to On, the power supply of the unit goes Off 10 minutes after the input signals stop.
This function is effective for input signals except input from PC (Mini D-sub) terminal.
Press to select “Power save” “Standby save” “Power management” “Auto power off”.
Press to select “On” or “Off”.
On Off
Setup | 1/2 |
Signal | |
Component/RGB-in select | |
| RGB |
Input label | PC |
Power save | Off |
Standby save | Off |
Power management | Off |
Auto power off | Off |
OSD Language | English (UK) |
1/2
Addition sign | “A” | “B” |
Selected Input | Composite | S VIDEO |