Panasonic TQB2A0952 Installation, Receiver Location, Optional External Equipment Connections

Page 5

Installation

Receiver Location

Locate for comfortable viewing. Avoid placing where sunlight or other bright light (including reflections) will fall on the screen.

Use of some types of fluorescent lighting can reduce remote control transmitter range.

Adequate ventilation is essential to prevent internal component failure. Keep away from areas of excessive heat or moisture.

To insure optimum color purity do not position magnetic equipment (motors, fan, other speakers, etc.) nearby.

Optional External Equipment Connections

The Video/Audio connections between components can be made with shielded video and audio cables. For best perfor- mance, video cables should utilize 75 ohm coaxial shielded wire. Cables are available from your dealer or electronic supply house.

Before you purchase any cables, be sure you know what type of output and input connectors your various components require. Also determine the length of cable you'llneed.

AC Power Supply Cord

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF AC OUTLET AND FULLY INSERT. DO NOT USE THIS (POLARIZED) PLUG WITH A RECEPTACLE OR OTHER OUTLET UNLESS THE BLADE CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

Polarized Plug

Remote Control Battery Installation & Replacement

Battery Installation

Batteries: Use two "AA" batteries.

1.Turn the Transmitter face down. To remove bottom cover, press down on marking and slide cover off in the direction indicated.

2.Install the batteries as shown in the battery compartment. (Polarity (+) or (-) must be correct.)

3.Replace the cover and slide in reverse until the lock snaps.

Precaution on Battery Use

Incorrect installation can cause battery leakage and corrosion that will damage the Remote Control Transmitter.

Observe the Following Precautions:

1.Batteries must be replaced as a pair.

2.Do not combine a used battery with a new one.

3.Do not mix battery types (Example: "Zinc Carbon" with "Alkaline").

4.Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.

5.Battery replacement is necessary when Remote Control reacts sporadically or stops operating the Receiver.

IIII II

® ®

_J {u

4.,I 4,,I

4.1

® ®

Slide Cover Back

Press Down Here And

ooooooooo

ooooooo ooooo

ooo

J

-5-

Image 5
Contents Color Television Operating Instructions NECSECTIONe10-21 Lightning flash with arFollow all warnings and instructions marked Without notice or obligation SpecificationsIntroduction ContentsAC Power Supply Cord InstallationRemote Control Battery Installation & Replacement Receiver LocationOther Video Equipment Antenna/Cable ConnectionsIncoming Cable From Home Antenna 75 Ohm Incoming Cable From Home Antenna 300 OhmPicture in Picture External Video and Antenna Connection Location of Controls Receiver Quick Reference Control Operation Receiver Ov0 =zEPAE Location of Controls Remote ControlQuick Reference Control Operation Remote Control Channel Change- Two options Volume Buttons Press the Volume VOLChannel Caption Station Identifier TV/Video Button Press the Tvnideo buttonTune Rapid Tune PresstheR-TUNE Multi Button Audio will be that of the Main Picture Cable Power Button The Cable PowerPIP Operation SmallPIPFramePIP Move Button The PIP frame may be Franais Main Menu IconsIAI Sndi AI Artificial IntelligenceColor, Tint, Brightness, Picture Sharpness Adjustments Picture AdjustmentsVideo NR Noise Reduction- This Auto Color and Video NRTreble Balance Surround Bass, Treble & Balance AdjustmentBass Audio Mode Stereo/SAP/Mono Speaker Off/On Audio Mode SelectionPIP Size Large/Small PIP FeaturesPIP Off/On PIP Picture in Picture Input Selection Input SelectMain Picture Input Selection Program Timer Timer FeaturePage ILoc Lock Feature Activated To unlock the Lockout feature follow Steps 1 throughFavorite Channel Feature Favorite Channel Select- The Favorite Fav Oh Select# 3 I H liil Channel Caption FeatureChannel Caption Station Identifier Closed Caption/Field Mode- This Closed Caption11-oo7ON Mute Displays and Exits MenusCC Closed Caption On Mute Recommended Set Up for Closed Caption when using Mute ButtonIENiil Language Menu SystemLanguage Selection English/Spanish/French IiM Set Up FeaturesTV/Ant or Cable Tuning Mode Mode TV/Ant or CableAfter Auto Programming Auto ProgramAuto Programming The Auto Programming Manual Program Manual Programming -Thisfeature allowsSequence Method for Cable Television Programming The Universal Remote ControlProcedure Infra-Red Code Index For Cable Television Converter Box Remote Control Infra-Red Code Index For VCRsVCR and Cable Converter Box Infra-Red Codes Index To Audio AMP Connection Stereo Optional Equipment Connection and OperationVideo/Audio Connection To Audio AMPVideo Connection Ople ,oRemote Control Transmitter Care and CleaningPicture Tube Turn set off Plastic CabinetsSymptoms PictureSound Troubleshooting ChartElectronics Matsushita Electric of Canada Limited Company