Timer Recording

Timer recording can be programmed on screen with the remote control. The built-in timer allows automatic unattended recording of up to 8 programmes within 1 month.

Preparation

•Load a cassette tape with the erase prevention tab intact. The unit will automatically turn on.

•Make sure that the clock shows the present time correctly.

EXAMPLE:

Programme a timer recording for 13:00-14:30, channel 3, on timer programme number 1 (Tape speed : LP).

1 Press TV/VCR to select TV/VCR mode.

Press MENU.
Check that the TIMER REC	TIMER REC SET
Check that the TIMER REC	TIMER REC SET
2 SET option is selected, then	AUTO REPEAT	OFF
press ENTER.	CHANNEL SETUP
	CHANNEL SETUP
	TV SETUP


	SYSTEM SETUP

SELECT :

ENTER : ENTER

EXIT : MENU

3 Press ▲ or ▼ to select one of the program lines, then press

ENTER.

NOTES:

• If programming is performed without a

tape in the unit, or with a tape without

an erase prevention tab, Timer

Recording is not possible. If a tape

without an erase prevention tab is in

the unit, the tape will be ejected.

• To record from external equipment

connected via the SCART socket

(AV1) or the front AV socket (AV2),

press or repeatedly until “AV1” or

“AV2” appears when setting the channel

in step 5.

• The VCR section cannot be used

while the TIMER REC indicator is lit. If

you want to use the VCR operation,

press TIMER REC to deactivate the

Pressorto select the desired date or every day or every week setting, then press ▼.

Set the start time, end time, channel and tape speed as in step 4.

When you have finished setting all your recordings, press ENTER. Press the MENU twice to return to normal TV screen.

•When you set the minute, you can change in 10-minutes step by holding down .

SELECT :		/ ENTER
EXIT	: MENU
TIMER REC SET
DATE		23 SAT
START		11: 30
END		– – : – –
CH			1
SPEED		SP
SELECT :		/ 0-9
SET	:
EXIT	: MENU
TIMER REC SET
DATE		23 SAT
START		13: 00
END		14: 30
CH			3
SPEED		LP
SELECT :
SET	:
EXIT	: MENU		OK : ENTER
23 SAT	13 : 00		14 : 30 3 LP

:	:
:	:
:	:
:	:
:	:
:	:
:	:
SELECT :	/ ENTER

EXIT : MENU

timer.

• If there is a power failure, the power

plug is disconnected, or the MAIN

POWER (ON) Switch is switched off

for more than approx. 30 mins, all

programmed timer recordings and

clock settings will be lost. In this case,

reset the clock (see page 11) and

reprogram any timer recordings.

• If you want to correct the digits while

setting, press ▲ until the item you

want to correct flashes, then press

or to correct the desired setting.

6 To set the timer for another programme, press ▲ or ▼ until a blank programme line blinks, then press ENTER. Repeat steps 4 to 5 to set the second programme.

7 Press TIMER REC. The TIMER REC indicator will light. The Timer is programmed, when the programmed time is reached, the recording is automatically started.

TIMER REC

To cancel timer recording, press the button again and TIMER REC indicator will go out.