SCART/Component, Hdmi Setup | Cambridge Audio DV30 instruction

SCART/Component

Note: HDMI output must be set to ‘Off’ for this menu to be accessible. Select between the following choices:

Component-p– Enables progressive scan component (YPbPr) using the 3 phono/RCA component outputs on the rear panel.

Component-i– Enables interlaced scan component (YCbCr) using the three phono/ RCA component outputs on the rear panel.

SCART RGB – Enables interlaced scan RGB + Sync using the SCART/Peritel output on the rear panel.

Note: Not all TV sets can accept Progressive Scan Component and a blank screen may result if the set does not support this format.

For Component-p, the component outputs will be 480p if the TV type has been set to NTSC, or 576p if the TV type has been set to PAL. Similarly for Component-i, the component outputs will 480i if the TV type has been set to NTSC, or 576i if the TV type has been set to PAL. If the Auto setting is used the format will follow the disc type.

Note:

•The Composite (CVBS) and S-Video outputs are always present and always output interlaced video, whether Component, RGB or HDMI is selected.

•Setting HDMI output to ‘On’ by selecting an output resolution disables the TV type and SCART/Component menus and, in fact, always forces the component outputs ‘On’ in component-p (Progressive Scan) format.

•With HDMI output ‘On’, all analogue video outputs will output PAL if a 50Hz HDMI mode is selected, or will output NTSC if a 60Hz HDMI mode is selected.

•With HDMI output ‘Off’, all analogue video outputs follow the TV type for their PAL/ NTSC mode choice.

DV30

ENGLISH

HDMI Setup

The default setting is ‘Enabled’. The default resolution is 720p (50Hz) for PAL, or 720p (60Hz) for NTSC. Should you wish to change the resolution, select the one you desire:

576p (50Hz) Progressive format PAL

720p (50Hz) Upscaled to PAL at 720 lines progressive

1080i (50Hz) Upscaled to PAL at 1080 lines interlaced

1080p (50Hz) upscaled to PAL at 1080 lines progressive

480p (60Hz) Progressive format NTSC

720p (60Hz) Upscaled to NTSC at 720 lines progressive

1080i (60Hz) Upscaled to NTSC at 1080 lines interlaced

1080p (60Hz) upscaled to NTSC at 1080 lines progressive

Note: Selecting a 50Hz format will automatically cause the TV Type menu item to show PAL. Selecting a 60Hz format will automatically cause the TV Type menu item to show NTSC.

Important! If you select an HDMI resolution that your TV does not support, you may lose the picture. In this case you may need to make an analogue video connection to your TV to be able to see the picture again and select another resolution in the Setup menu.