Quick guide
Using the Menu screen
You need to call up the OSD to perform settings for the TV. The OSD for the settings is called “Menu”. The “Menu” enables various settings and adjustments.
Display the Menu screen
Go to “TV Menu”.
• You can also display the Menu screen via the HOME menu screen (Page 13).
Using Software keyboard
Use the software keyboard when you need to input text.
6 | 7 | 8 |
Selecting in the Menu
Press c/dto select the desired menu, and then press ;. Press 6 to return to the previous menu category.
Press c/dto select the desired sub- menu, and then press ;.
Press a/bto select the item you want to select/adjust, and then press ;.
Menu
Selecting options
Press a/bor c/dto configure the control for
improving TV viewing, and then press ;.
EXAMPLE
Backlight
1 | Char.Set |
|
|
|
|
|
2 | Caps |
|
|
|
| 9 |
3 | Done |
|
|
| Clear | 10 |
4 | Cancel |
|
| SP | Delete | 11 |
|
|
|
| |||
|
|
|
|
|
| |
5 | Cursor Left | Caps | Char.Set |
| Cursor Right |
|
CH list | Setup |
:Enter | :Back |
Picture
AV mode
OPC
[Off]
Backlight
3D brightness boost
[Middle]
About the guide display
The guide display below the menu bar shows operations for the OSD.
•The bar above is an operational guide for the remote control unit. The bar will change in accordance with each menu setting screen.
|
|
|
|
|
| Yes |
| No |
|
|
|
|
|
|
NOTE
•Refer to the guide display
below the menu bar to see when to press the ;button.
CH list |
| Setup |
:Select | :Enter | :Back |
1 | Char. Set | 6 | Input cursor |
| Changes character |
| Press c/dto move the |
| set into the alphabet, |
| cursor when highlighted. |
| numbers, symbols, etc. | 7 | Input field |
2 | Caps |
| The text you enter is |
| Changes characters to |
| displayed as you type |
| capital/lower case. |
| it in. |
3 | Done | 8 | Character |
| Confirm the entry. |
| Input characters by |
4 | Cancel |
| using these buttons. |
|
| ||
| Abort input and close | 9 | ? |
| the software keyboard. |
| Put a line break. |
5R/G/Y/B (Colour) buttons
Selects the coloured items on the screen.
0Clear
Erases the character string.
•When the cursor is somewhere in a line: The character string to the right of the cursor will be erased.
•When the cursor is at the right end of a line: The entire line will be erased.
Q Delete |
If the cursor is at the |
right end of a line, |
this erases text one |
character at a time. |
• You can also delete |
text by pressing 6 |
NOTE
•“Menu” options differ according to the selected input modes, but the operating procedures are the same.
•Items with 4 cannot be selected for various reasons.
•Some items cannot be selected depending on signal types, optional settings or connected devices.
on the remote control |
unit. |
NOTE
•Depending on the application, there may be a different software keyboard than the one indicated above.
•When inputting letters in MHP services, use the numeric buttons on the remote control unit (858 series only).
14