Basic adjustment
Power save settings
Go to “HOME” > “TV Menu” > “Setup” > “ECO”.
Menu
| CH list | Setup |
: Select | :Enter | :Back |
ECO
ECO picture control
[On]
Energy save
[Off]
No signal off
[Disable]
No operation off
[Disable]
ECO
No signal off
When set to “Enable”, the TV will automatically enter standby mode if there is no signal input for 15 minutes.
NOTE
•Even if a TV programme finishes, this function may not operate because of interference from other TV stations or other signals.
ECO
No operation off
You can set the TV to automatically power off when no TV operation is performed for 30 minutes or 3 hours.
NOTE
• “Disable” is the factory preset value.
NOTE
• You can also select “ECO” by pressing ECO.
ECO
ECO picture control
This function automatically detects the image source and decreases the power consumption while keeping the brightness of the image unchanged.
NOTE
•This function does not work when “AV mode” is set to “DYNAMIC (Fixed)”, “DYNAMIC” or “AUTO”.
•This function does not work when “Energy save” is set to “Standard” or “Advanced”.
•This function is greyed out in 3D mode.
ECO
Sleep timer
Allows you to set a time when the TV automatically enters standby mode. You can set the time span for entering standby mode after selecting “Change”.
NOTE
•Select “Off” to cancel the sleep timer.
•When the time has been set, countdown automatically starts.
•Five minutes before the preset of time expires, the remaining time displays each minute.
ECO
Energy save
This function enables you to reduce the backlight brightness in order to decrease the power consumption and increase the backlight life span as shown in the following table.
| Item | |
Standard | Reduces the backlight brightness. | |
|
| |
Advanced | Reduces the backlight brightness more | |
than “Standard”. | ||
| ||
|
| |
Off | The backlight brightness is the same | |
value of your settings in the selected “AV | ||
| mode”. | |
|
|
When “Energy save” is set to “Standard” or “Advanced”, “Energy save” status icons appear in the “Picture” menu and channel information windows.
NOTE
•This function does not work when “AV mode” is set to “DYNAMIC (Fixed)”.
39