Sylvania LC320SL8 owner manual Still Mode, Switching Each Mode

Page 16

WATCHING TV

5Still Mode

You can freeze the image shown on the TV screen.

Press [STILL] to pause the image shown on the screen.

Still

•The sound output will not be paused.

•If no signal is detected or protected signal is received during still mode, the image remains paused and the sound output will be muted.

•The still function will be released after 5 minutes.

To cancel still mode, press any button except [POWER].

5Switching Each Mode

You can easily switch with the remote control to the DTV (ATSC) and TV (NTSC) or to access an external device when they are connected to the unit.

Press [INPUT SELECT] or [CH K] repeatedly to cycle through the input modes.

TV/DTV channel

Video1

or

Video2

Component1

Component2

HDMI

•Pressing [CH L] reverses the direction of the mode.

•To use the video or S-video input jack of VIDEO 1 on the unit, select “Video1”.

•To use the video or S-video input jack of VIDEO 2 on the unit, select “Video2”.

•To use the component video input jack of COMPONENT 1 on the unit, select “Component1”.

•To use the component video input jack of COMPONENT 2 on the unit, select “Component2”.

•To use the HDMI - IN jack on the unit, select “HDMI”.

16

EN

Image 16

Contents To Receive DIGITAL/ANALOG SIGNAL, YOU Must Connect Antenna LC320SL8Introduction Important note is located on the rear of the cabinetPrecautions RADIO-TV InterferenceSupplied Accessories Symbols Used in this ManualRemote control LocationContents FeaturesDTV/TV/CATV Remote Control Function Installing the BatteriesControl Panel Rear PanelConnection Basic ConnectionAntenna Cable Connection Connection to Cable Box or Satellite BoxHdmi Connection External Device ConnectionHDMI-DVI Connection Component Video Cable Connection Video Cable ConnectionAudio Output Connection Digital Video ConnectionAnalog Initial Setting Initial SetupMake sure if the unit is connected to antenna or cable Scanning and memorizing of channels start automaticallyMain Menu Auto Channel ScanLanguage Selection Press Setup to exitLanguage Watching TV 5Volume AdjustmentChannel Selection Still Mode Switching Each ModeYou can freeze the image shown on the TV screen To use the Hdmi in jack on the unit, select HdmiSwitching Audio Mode StereoSAP MonoScreen Information Press InfoBroadcasting Information Day of MemoriesiTV Screen Display Mode Press Sleep to set the sleep timer Sleep TimerTo Cancel the Sleep Timer Channel List Optional Setting5Manual Register Antenna Confirmation AntennaPicture Adjustment Closed Caption DTV CC DTV Closed CaptionUse Cursor K/L to select DTV CC, then press Font Style CC StyleFont Size Font Color Font OpacityBack Color Back OpacitySee the following description for setting each item Chipip Enter passwordChip Use Cursor K/L to select V-chip, then pressPress Setup to exit Use Cursor K/L to select Mpaa Rating, then press EnterView and Block To Set the Sub RatingsUse Cursor K/L to select New Password, then press Enter Chipip Enter password Confirm passwordYou can set the method of sound input for the Hdmi in jack Hdmi AudioUse Cursor K/L to select Hdmi Audio, then press Troubleshooting Troubleshooting GuideCheck the batteries of the remote control Refer to IR Signal Check onInterrupt the remote control signal of this unit Delayed behind the dialogueMaintenance InformationGlossary AtscGeneral Specifications Electrical SpecificationOther Specifications Cable Channel DesignationsLimited Warranty