Sylvania LC320SL8 owner manual Antenna Confirmation

Page 22

OPTIONAL SETTING

5Antenna Confirmation

This function lets you check the signal strength of each channel.

1 Press [SETUP] to display the main menu.

2 Use [Cursor K/L] to select “CHANNEL”, then press [ENTER].

3 Use [Cursor K/ L] to select “Antenna”, then press

[ENTER].

Channell

Autoscan

Channel List

Manual Register

Antenna

4 Use [the Number buttons] or [CH K/L] to select the channel for which you want to check the signal strength.

11

Antenna

Back

Now

0

Peak

0

 

 

 

 

CH Ch Change

If the channel is set to external input, you cannot confirm the antenna condition.

Video1

Antenna

Back

Indicator is available for antenna signal only.

CH Ch Change

5 Press [SETUP] to exit.

22

EN

Image 22
Contents To Receive DIGITAL/ANALOG SIGNAL, YOU Must Connect Antenna LC320SL8Introduction Important note is located on the rear of the cabinetPrecautions RADIO-TV InterferenceRemote control Supplied AccessoriesSymbols Used in this Manual LocationContents FeaturesDTV/TV/CATV Remote Control Function Installing the BatteriesControl Panel Rear PanelAntenna Cable Connection ConnectionBasic Connection Connection to Cable Box or Satellite BoxHdmi Connection External Device ConnectionHDMI-DVI Connection Component Video Cable Connection Video Cable ConnectionAudio Output Connection Digital Video ConnectionAnalog Make sure if the unit is connected to antenna or cable Initial SettingInitial Setup Scanning and memorizing of channels start automaticallyMain Menu Auto Channel ScanLanguage Selection Press Setup to exitLanguage Watching TV 5Volume AdjustmentChannel Selection You can freeze the image shown on the TV screen Still ModeSwitching Each Mode To use the Hdmi in jack on the unit, select HdmiSAP Switching Audio ModeStereo MonoBroadcasting Information Screen InformationPress Info Day of MemoriesiTV Screen Display Mode Press Sleep to set the sleep timer Sleep TimerTo Cancel the Sleep Timer Channel List Optional Setting5Manual Register Antenna Confirmation AntennaPicture Adjustment Closed Caption DTV CC DTV Closed CaptionUse Cursor K/L to select DTV CC, then press Font Style CC StyleFont Size Back Color Font ColorFont Opacity Back OpacityChip See the following description for setting each itemChipip Enter password Use Cursor K/L to select V-chip, then pressView and Block Press Setup to exitUse Cursor K/L to select Mpaa Rating, then press Enter To Set the Sub RatingsUse Cursor K/L to select New Password, then press Enter Chipip Enter password Confirm passwordYou can set the method of sound input for the Hdmi in jack Hdmi AudioUse Cursor K/L to select Hdmi Audio, then press Troubleshooting Troubleshooting GuideInterrupt the remote control signal of this unit Check the batteries of the remote controlRefer to IR Signal Check on Delayed behind the dialogueGlossary MaintenanceInformation AtscOther Specifications General SpecificationsElectrical Specification Cable Channel DesignationsLimited Warranty