Sylvania LC320SL8 Supplied Accessories, Symbols Used in this Manual, Location, Remote control

Page 4

INTRODUCTION

LOCATION

For safe operation and satisfactory performance of the unit, keep the following in mind when selecting a place for its installation:

Shield it from direct sunlight and keep it away from sources of intense heat.

Avoid dusty or humid places.

Avoid places with insufficient ventilation for proper heat dissipation. Do not block the ventilation holes at the top and bottom of the unit. Do not place the unit on a carpet because this will block the ventilation holes.

Install the unit in a horizontal position.

Avoid locations subject to strong vibration.

Do not place the unit near strong magnetic fields.

Avoid moving the unit to locations where temperature differences are extreme.

Be sure to unplug the AC power cord from the outlet before carrying the unit.

TO AVOID THE HAZARDS OF ELECTRICAL SHOCK AND FIRE

Do not handle the power cord with wet hands.

Do not pull on the power cord when disconnecting it from an AC outlet. Grasp it by the plug.

If, by accident, water is spilled on the unit, unplug the power cord immediately and take the unit to our authorized service center for servicing.

Do not place anything directly on top of the unit.

The serial number of this product may be found on the back of the unit. No others have the same serial number as yours. You should record the number and other vital information here and retain this book as a permanent record of your pur- chase to aid identification in case of theft.

date of purchase

 

dealer phone No.

 

serial No

 

dealer purchase from

 

model No.

 

dealer address

 

 

 

 

 

 

 

Note about recycling:

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

5Supplied Accessories

owner’s manual

 

 

 

remote control

 

 

 

batteries

(1EMN22190)

 

 

 

(NF015UD)

 

 

 

(AA x 2)

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

Depending on your antenna system, you may need different types of combiners (mixers) or separators (splitters). Contact your local electronics store for these items.

5Symbols Used in this Manual

The following is the description for the symbols used in this manual.

Description refers to:

DTV : Digital TV operation

TV : Analog TV operation

• If neither symbol appears under the function heading, operation is applicable to both.

4

EN

Image 4
Contents To Receive DIGITAL/ANALOG SIGNAL, YOU Must Connect Antenna LC320SL8Introduction Important note is located on the rear of the cabinetPrecautions RADIO-TV InterferenceSupplied Accessories Symbols Used in this ManualRemote control LocationContents FeaturesDTV/TV/CATV Remote Control Function Installing the BatteriesControl Panel Rear PanelConnection Basic ConnectionAntenna Cable Connection Connection to Cable Box or Satellite BoxHdmi Connection External Device ConnectionHDMI-DVI Connection Component Video Cable Connection Video Cable ConnectionAudio Output Connection Digital Video ConnectionAnalog Initial Setting Initial SetupMake sure if the unit is connected to antenna or cable Scanning and memorizing of channels start automaticallyMain Menu Auto Channel ScanLanguage Selection Press Setup to exitLanguage Watching TV 5Volume AdjustmentChannel Selection Still Mode Switching Each ModeYou can freeze the image shown on the TV screen To use the Hdmi in jack on the unit, select HdmiSwitching Audio Mode StereoSAP MonoScreen Information Press InfoBroadcasting Information Day of MemoriesiTV Screen Display Mode Press Sleep to set the sleep timer Sleep TimerTo Cancel the Sleep Timer Channel List Optional Setting5Manual Register Antenna Confirmation AntennaPicture Adjustment Closed Caption DTV CC DTV Closed CaptionUse Cursor K/L to select DTV CC, then press Font Style CC StyleFont Size Font Color Font OpacityBack Color Back OpacitySee the following description for setting each item Chipip Enter passwordChip Use Cursor K/L to select V-chip, then pressPress Setup to exit Use Cursor K/L to select Mpaa Rating, then press EnterView and Block To Set the Sub RatingsUse Cursor K/L to select New Password, then press Enter Chipip Enter password Confirm passwordYou can set the method of sound input for the Hdmi in jack Hdmi AudioUse Cursor K/L to select Hdmi Audio, then press Troubleshooting Troubleshooting GuideCheck the batteries of the remote control Refer to IR Signal Check onInterrupt the remote control signal of this unit Delayed behind the dialogueMaintenance InformationGlossary AtscGeneral Specifications Electrical SpecificationOther Specifications Cable Channel DesignationsLimited Warranty