Sylvania LC320SL8 owner manual Basic Connection, Antenna Cable Connection

Page 8

CONNECTION

Cables not included.

Please purchase the necessary cables at your local store.

5Basic Connection

This section describes how to connect the unit to an antenna, cable/satellite box, etc.

Note:

• Be sure your antenna or other device is connected properly before plugging in the power cord.

[Antenna Cable Connection]

When connecting the unit to an antenna or cable TV company (without cable/satellite box)

Connect the RF coaxial cable on your home outlet to the antenna input jack of this unit.

e.g.)

	VHF / UHF	rear of this unit
	antenna	rear of this unit
	antenna

RF coaxial cable

or

cable TV company

*Once connections are completed, turn on the unit and begin initial setup.

Channel scanning is necessary for the unit to memorize all available channels in your area. (Refer to “Initial Setup” on page 12.)

Note:

•For your safety and to avoid damage to device, please unplug the RF coaxial cable from the antenna input jack before moving the unit.

•If you use an antenna to receive analog TV, it should also work for DTV reception. Outdoor or attic antennas will be more effective than settop versions.

•To easily switch your reception source between antenna and cable, install an antenna selector.

•If you connect to the cable system directly, contact the CATV installer.

[Connection to Cable Box or Satellite Box]

Connect the RF coaxial cable on your home outlet to the input jack of the cable/satellite box.

Use another RF coaxial cable to connect the antenna input jack of the unit to the output jack of the cable/satellite box.

e.g.)

satellite dish

or

cable TV company

rear of this unit

		cable/satellite box


	ANT. IN	RF OUT

RF coaxial cable			RF coaxial cable

*Required cables and connecting methods differ depending on the cable/satellite box. For more information, please contact your cable/satellite provider.

8

EN

Image 8

Contents To Receive DIGITAL/ANALOG SIGNAL, YOU Must Connect Antenna LC320SL8Introduction Important note is located on the rear of the cabinetPrecautions RADIO-TV InterferenceSupplied Accessories Symbols Used in this ManualRemote control LocationDTV/TV/CATV FeaturesContents Remote Control Function Installing the BatteriesControl Panel Rear PanelConnection Basic ConnectionAntenna Cable Connection Connection to Cable Box or Satellite BoxHDMI-DVI Connection External Device ConnectionHdmi Connection Component Video Cable Connection Video Cable ConnectionAnalog Video ConnectionAudio Output Connection Digital Initial Setting Initial SetupMake sure if the unit is connected to antenna or cable Scanning and memorizing of channels start automaticallyMain Menu Auto Channel ScanLanguage Press Setup to exitLanguage Selection Channel Selection 5Volume AdjustmentWatching TV Still Mode Switching Each ModeYou can freeze the image shown on the TV screen To use the Hdmi in jack on the unit, select HdmiSwitching Audio Mode StereoSAP MonoScreen Information Press InfoBroadcasting Information Day of MemoriesiTV Screen Display Mode To Cancel the Sleep Timer Sleep TimerPress Sleep to set the sleep timer 5Manual Register Optional SettingChannel List Antenna Confirmation AntennaPicture Adjustment Closed Caption Use Cursor K/L to select DTV CC, then press DTV Closed CaptionDTV CC Font Size CC StyleFont Style Font Color Font OpacityBack Color Back OpacitySee the following description for setting each item Chipip Enter passwordChip Use Cursor K/L to select V-chip, then pressPress Setup to exit Use Cursor K/L to select Mpaa Rating, then press EnterView and Block To Set the Sub RatingsUse Cursor K/L to select New Password, then press Enter Chipip Enter password Confirm passwordUse Cursor K/L to select Hdmi Audio, then press Hdmi AudioYou can set the method of sound input for the Hdmi in jack Troubleshooting Troubleshooting GuideCheck the batteries of the remote control Refer to IR Signal Check onInterrupt the remote control signal of this unit Delayed behind the dialogueMaintenance InformationGlossary AtscGeneral Specifications Electrical SpecificationOther Specifications Cable Channel DesignationsLimited Warranty