Sylvania LC320SL1 Supplied Accessories, Symbols Used in this Manual, Attaching the Base

Supplied Accessories

Owner’s manual	Quick Start
(1EMN25719)	(1EMN25723)

Remote control			Registration card
(NH001 UD)			(1EMN24700)
	OK
VOL		CH
1	2	3
4	5	6
7	8	9
PREV CH	0 .

Batteries	Screw kit
(AAA, 1.5V x 2)	for attaching the base
	(1ESA19881 )
AAA
AAA

•If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free customer support line found on the cover of this manual.

Note

If you lose the screws, please purchase M4×20 Phillips head screws at your local store.

Symbols Used in this Manual

The following is the description for the symbols used in this manual. Description refers to:

ATSC : Digital TV operation

NTSC : Analog / Cable TV operation

•If neither symbol appears, the operation is applicable to

both.

English

			INTRODUCTION
Attaching the Base
You must attach the base to the unit to have it as a table top
unit. Be sure the front and rear of the base match the proper
direction.
1 Spread a thick and soft
cloth over a table as
			PREPARATION
shown.
Place the main unit face
down onto it. Make sure
not to damage the screen.
At least 2 people are
required for this step.
2 Insert 2 hooks under the
			WATCHING
bottom of the main unit
into base holes. (shown by ➁
arrow ➀), then move the
base in the direction as			TV
shown by arrow ➁ until it
		➀
stops and the 4 mounting
holes are aligned.			OPTIONAL
3 Drive Phillips pan screws
into the 4 threaded holes
at the bottom of the base			SETTING
until they are tight.
To remove the base from this unit
			TROUBLESHOOTING
When attaching the base, ensure that all screws are tightly fastened. If the
Unscrew the Phillips pan screws on step	3
After the screws are removed, move the base in the opposite direction as
shown by arrow ➁ on step 2, then pull the base up toward the rear of the
unit. Be careful not to drop the base when you remove it.
Note
base is not properly attached, it could cause the unit to fall, resulting in
injuries as well as damage to the unit.			INFORMATION
Make sure to use a table which can support the weight of this unit and is
larger than this unit.
Make sure the table is in a stable location.
When attaching the base, ensure that FRONT ↑ written on the base is
upward. If it's not upward, the 2 hooks don't fit in the base.

Fixing the Unit on Your Furniture

Screw this unit on your furniture tightly using wood screws (not supplied) in the 2 holes at the back of the base as shown.

Recommended screw dimension : 5.1 x 20 mm

rear of this unit

Note

•When you remove this unit make sure to unscrew the wood screws from your Wood Stand, Furniture and other wood item.

5

EN