Sylvania LC320SL1 owner manual Troubleshooting, Question Answer

English

TROUBLESHOOTING			INTRODUCTION
FAQ
			PREPARATION
Question	Answer
	• Check the antenna or cable connection to the main unit.
	• Check the batteries of the remote control.
	• Check if there is an obstacle between the infrared sensor window and the remote
		control.
My remote control does not	• Test the signal output. If OK, then possible infrared sensor trouble.
	•	[IR Signal Check] ➠ p.34	WATCHING
work.		When there is an infrared-equipped device such as PC near this unit, it may interrupt
	•	Aim the remote control directly at the infrared sensor window on the front of the unit.
What should I do?	•	Reduce the distance to the unit.
	• Re-insert the batteries with their polarities (+/– signs) as indicated.
		the remote control signal of this unit.	TV
	• Move the infrared-equipped device away from this unit, change the angle of the infrared
		sensor or turn off the infrared communication function.
this unit?			OPTIONALOPTI
	•	Make sure to complete the channel scan before turning off the unit.
How come the Initial setup	•	Connect the RF coaxial cable to the unit directly and run the initial setup.
appears every time I turn on
			SETTINGTING
		to a location where previously unavailable channels are broadcast.
	• Make sure [Autoprogram] has been completed. ➠ p.19
	• Autoprogram must be completed when you set up the unit for the first time or move it
	• The selected channel may not be broadcasting.
			ITROUBLESHOOTING
Why I cannot watch some RF	•	When [Autoprogram] is interrupted and not completed, some channels will not be
signal TV programs.		received. Make sure to complete. ➠ p.19
	• The selected channel cannot be viewed by the [Child Lock] setting. ➠ p.27
	• The unit requires some kind of antenna input. An indoor antenna
		(VHF /UHF), an external antenna (VHF /UHF) or an RF coaxial cable from your wall
		cable/satellite box needs to be plugged into the unit.
	• Check if the right input mode is selected by pressing SOURCE or using CH ▲/▼.
How come there is no image		[Switching Each Input Mode] ➠ p.16	INFORMATION
	• Check the antenna or cable connection to the unit.
from the connected external
	•	When using the Component Video Connection check that the Green (Y), Blue (Pb/Cb)
devices?
		and Red (Pr/Cr) connectors are connected to their corresponding colored jacks on the
		unit.
	• Many digital channels have alternate channel numbers.
Whenever I entered channel		The unit changes the numbers automatically to the ones signifying the broadcasting
number,		station channel number.
it changes automatically.		These basic numbers used for previous analog broadcasts.
		(e.g., input ch#30 auto change to ch#6.1)

Why are captions not displayed entirely?

Or, captions are delayed behind the dialogue.

How can I set the clock ?

•Captions that are delayed a few seconds behind the actual dialogue are common for live broadcasts. Most captioning production companies can display a dialogue to maximum of 220 words per minute. If a dialogue exceeds that rate, selective editing is used to insure that the captions remain up-to date with the current TV screen dialogue.

• There is no clock function on this unit.

31

EN