Sylvania SRCD227 Front of the TV/DVD/VHS Output jack, To Record a SCRAMBLED/UNSCRAM Bled Channel

TD530XA/601XB 01-36 02.8.26 11:44 AM Page 12

TO RECORD A SCRAMBLED/UNSCRAM-

BLED CHANNEL

1. Set the TV/DVD/VHS channel selector to the out- put channel of the Cable Converter Box or Satellite Box. (Ex. CH3)

2.Select the channel to record from your Cable Converter Box or Satellite Box.

Note to CATV system installer:

This reminder is provided to call the CATV sys-

tem installer's attention to Article 820-40 of the NEC that provides guidelines for proper ground- ing and, in particular, specifies that the cable ground shall be connected to the grounding sys- tem of the building as close to the point of cable entry as practical.

When you watch a program recorded on an another source (VCR or video camera), use the audio/video input jacks on the front of the TV/DVD/VHS.

Connect the audio/video output jacks of another source to the AUDIO L/R and VIDEO jacks of this TV/DVD/VHS.

Then press the CHANNEL A/V buttons until "AUX" appears on the screen.

You may access the front A/V Input directly by pressing the numbers 00 on the remote control. See page 9.

NOTE:

• When you connect a monaural VCR (another

source) to this TV/DVD/VHS, connect the Audio output jack of the monaural VCR (another source)

to the AUDIO L jack of this TV/DVD/VHS. The audio will output in both L and R channel equally.

To the audio output jacks

Another source

Audio/Video coaxial cable (not supplied)

1)Open the battery compartment cover by pressing the cover on the remote unit in the direction of the arrow.

2)Insert 2 "AA" penlight batteries into the battery

compartment in the direction indicated by the polarity (+/-) markings.

3)Replace the covet:

etc.

[Front of the TV/DVD/VHS]

output jack

[Fig. 51

- 12-EN 1(229