Sylvania DigitalVideoDiscRecorder owner manual Precautions, Laser Safety, RADIO-TV Interference

Page 2

PRECAUTIONS

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

The caution marking is located on the rear of the cabinet.

Laser Safety

This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.

CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

CAUTION: VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED. DO NOT STARE INTO BEAM.

LOCATION: INSIDE, NEAR THE DECK MECHANISM.

FCC WARNING- This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the modifications are expressly approved in the manual. The user could lose the authority to operate this equipment if an unauthorized change or modification is made.

RADIO-TV INTERFERENCE

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1)Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.

ATTENTION: POUR ÉVITER LES CHOCS ÉLECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQU’AU FOND.

A NOTE ABOUT RECYCLING

This product’s packaging materials are recyclable and can be reused. Please dispose of any materials in accordance with your local recycling regulations.

Batteries should never be thrown away or incinerated but disposed of in accordance with your local regulations concerning chemical wastes.

Make your contribution to the environment!!!

•Used up batteries do not belong in the dust bin.

•You can dispose of them at a collection point for used up batteries or special waste. Contact your council for details.

For Customer Use:

Read carefully the information located at the back of this unit and enter below the Model No. and Serial No. Retain this information for future reference.

Model No. _____________________

Serial No. _____________________

2EN

Page 1 Page 3
Image 2
Page 1 Page 3
Contents ZC320SL8B Make your contribution to the environment PrecautionsLaser Safety RADIO-TV InterferenceImportant Safeguards PrecautionsMoisture Condensation Warning Installation Location Supplied AccessoriesAvoid the Hazards of Electrical Shock and Fire About CopyrightCleaning discs Maintenance ServicingCleaning the cabinet Cleaning the disc lens Disc handlingContents Features Features DVD-RRegion Codes Unplayable DiscsColor Systems DVD-VIDEO CD-DA CD-RWFunctional Overview Front PanelFunctional Overview Rear PanelUsing a Remote Control Remote ControlInstalling the Batteries in the Remote Control Open the cover Insert batteriesSetup button Timer PROG. buttonPower button Zoom buttonWith the clock display Front Panel DisplayDisplay Message Current status of the unitMake the connection as illustrated below Plug in the power cords of the devices to the AC outletFollowing the steps in Settings for the Video in R Supplied cables used in this connection are as followsIf you want to use S-VIDEO in jack, select S-Video Settings for the Video InputPress Setup to exit This unit Connection to a TVConnections Basic Audio OUT Video OUTAudio OUT Connection to AN Audio SystemAudio Disc Information/Menu Title Name Information On-Screen Display / MenuOFF File Name InformationGuide to ON-SCREEN Displays and Menus Main MenuPress Enter to activate Clock Initial SettingProceed to in Clock Setting on Use K / L to select calendar or time, then press Enter Setting the ClockClock Setting Formatting a Disc Choosing the Recording Format of a Brand-New DVD-RWReformatting a Disc Manually If you want to cancel formatting, select NoFormatting a Disc Formatting is completed.100% is indicatedPress Setup to exit Setting for Auto ChapterSetting Aspect Ratio for Video Mode Recording Preparing a DiscOFF ON, then press ENTER. e.g. VR mode DVD-RW Setting a Disc to ProtectTo cancel the disc protect Use K / L to select Yes, then press EnterAuto Finalizing General Setting menu will appearYour setting will be activated Use K / L to select Recording, then press EnterFinalizing a Disc Press Setup Use K / L to select DVD Menu, then press EnterPlaying the Discs in Other DVD Players Finalizing is completedTo cancel finalizing DVD-RW only Restrictions on Recording Information on DVD RecordingRecording Speed VideoPress REC Speed to select a recording speed Press PowerPress OPEN/CLOSE a to close the disc tray It may take awhile to load Disc completelyWill be displayed for 5 seconds Press Stop C to stop recordingPress REC/OTR to start recording Use K / L to enter the date, then Timer RecordingPress B To exit, press Timer PROG. or Setup Timer RecordingPress Power to set a timer programming Use K / L to select a recordingPress Timer PROG. to exit To stop the timer recording in processPress Power Hints for Timer Recording Priority of Overlapped SettingsSpeed Satellite LinkUse K / L to set the desired starting time, then press B Use K / L to select the recordingSatellite Link To Standby Mode is highlightedPress Power to turn on the unit Press EnterConnection to an External Device External deviceSettings for AN External Device Recording from an External DeviceStructure of Disc Contents Information on PlaybackDirect Playback Refer to Using the Title/Disc Menu onBasic Playback Press Stop C once to stop playback temporarilyUse K / L to select Play From Basic PlaybackPlayback from the Title List Start, then press EnterJpeg pictures can also rotate by using K / L / / B Disc trayKodak Picture CD Using the Title / Disc MenuPause Fast Forward / Fast Reverse Playback Special PlaybackResume Playback Skipping TV Commercials During PlaybackStep by Step Playback Special PlaybackRapid Playback Slow Forward / Slow Reverse PlaybackDVD-video Marker SettingZoom Title track number and the time will be displayedSearch Using Skip j / SkipUsing Display Title/Chapter SearchAudio CD SearchTime Search Repeat Playback Random PlaybackProgram Playback 5Press Play BSwitching Subtitles Switching Audio SoundtrackSelecting the Format of Audio and Video Switching Virtual Surround SystemSwitching Camera Angles Reducing Block NoiseInformation on Disc Editing Guide to a Title ListDeleting Titles After the disc is fully recordedDeleting Titles CREATING/DELETING Playlist Adding Titles to a PlaylistUse K / L to select Yes, then press ENTER.DVD Menu CREATING/DELETING PlaylistErasing All Playlist Main menu will appearUse K / L to select Edit Title Name, then press Enter Editing DiscsPutting Names on Titles Use K / L to select Edit, then pressGuide to Edit Title Name Editing DiscsPutting Names on Titles cont’d Press Return Setting or Clearing Chapter MarksUse Skip H / G Submenu will appearDeleting a Part of a Title Part of the title is deleted Deleting a Part of a Title cont’dUse K / L to select Delete then press Enter Press Return or Stop C to exit For VR mode DVD-RW, press MENU/LIST to select PlaylistDividing a Title You can divide one title into 2 new titlesCombining, then press Enter Combining TitlesUse K / L/ / B to select another Title to combine, then press EnterConfirm the indication OFF ON. Press Enter again Setting or Releasing the Title ProtectionTo protect a whole disc VR mode DVD-RW only Press Return and then Return or Stop C to exitUse K / L to select the desired interval, then press Enter Setting or Clearing All Chapter Marks at OnceUse K / L to select Chapter Mark If you select OFF at , all the chapter marks are erasedList of Settings ContentsList of Settings 70 ENUse K / L to select a desired item SetupsPlayback Refer 1 to 7 on pages 72 to 74Use the Number buttons to enter the current password SetupsParental Lock Default All Playback cont’dAudio Out Disc Menu Language Default EnglishAudio Language Default Original PCMStill Mode Default Auto Subtitle Language Default OFFAngle Icon Default on Display Selection menu will appearFL Dimmer Default Bright OSD Language Default EnglishScreen Saver Default 10 minutes Display cont’dRefer 1 to 2 on page 78 and set the selected item When you finish with the setting, press Setup to exitVideo For 3 , refer to Connection to an External Device onVideo cont’d Progressive Default OFFTV Aspect Default 43 Letter Box Select Yes again using K / L , then press Enter Reset AllSelect Yes using K / L , then press Enter Function SetupTroubleshooting Symptom RemedyStop C TroubleshootingRecording / Timer recording / Editing Others OPEN/CLOSE a to take out the disc. The disc canceled duringRepairing process MAY not work You press OPEN/CLOSE aError message Cause Solution Frequently Asked Questions Language Code Language CodeGlossary Recording SpecificationsGeneral TerminalsCódigos de Región EspañolDiscos no Reproducibles Disco simple de video VSDUtilice K / L para seleccionar la Presione Setup y utilice K / LEspañol Posición de la entrada externaPresione REC/OTR para iniciar la grabación Presione PowerPresione Enter para activar Ajste Manual de Reloj Para de tener la grabación presione Stop CAbra la bandeja Presione Timer ProgConfigure una programación del temporizador Presione Enter Detenga laE7E2BUD Customer ServiceTel 1VMN23640
Top Page Image Contents