Dell W2600 owner manual Problem

Problem Possible Solution

Poor picture quality when using a device connected to the ANT/Cable (coaxial) connector

Nothing appears on my TV

1 Ensure TV is selected as the input source in the Input Select menu. See "Input Select Menu" on page 30 for more information.

2 Press Menu on the remote control, select Setup, and then select Channel Setup. This resets the channels.

3 Check the aspect ratio settings in the OSD. Press the Menu button on the remote control and select Size. For more information on using the OSD, see "Using the On-Screen Display" on page 29.

4 Reset the original factory defaults. Press Menu on the remote control, select Setup, and then select Factory Reset.

5 Adjust the color temperature. Press Menu on the remote control, select Picture, and then select Color Temperature.

6 The problem may be with your device, contact your service provider.

1 Ensure the TV is turned on.

2 Verify that all the cables are properly connected to the TV, including the power cable.

3 Check to see if there is a blue or amber light on the lower, right-hand corner of the TV. A blue light indicates the TV is on. An amber light, means the TV is in power save mode.

4 Ensure the proper source is selected in the Input Select menu. See "Input Select Menu" on page 30 for more information.

5 Reconnect any devices that are currently connected to the TV. If you are using multiple devices, connect and test one device at a time.

6 Connect another device that you know is working properly.

7 Reset the original factory defaults. Press Menu on the remote control, select Setup, and then select Factory Reset.

Troubleshooting Your TV

39