SETTING
USB
This Projector is equipped with USB port for interactive operation between a projector and computer. Set mode following steps below.
Wireless Mouse mode
Select " " when controlling a computer with Remote Control of this projector.
Projector mode
Select " " when controlling a projector with computer.
NOTE: This is provided not for basic operation but for future use.
Key lock
This function locks the operation of the projector's control panel and the remote control.
This locks operation of the projector's control panel.
This locks operation of the remote control.
This cancels the Key lock function.
If the projector's control panel accidentally becomes locked and you do not have the remote control nearby, disconnect the AC cord to turn off the power, and then while pressing a SET button, reinsert the AC cord, This will cancel the projector's control panel lock.
Lamp counter reset
This function is used to reset Lamp Replace Counter. When replacing Projection Lamp, reset Lamp Replace Counter by using this function. Refer to page 45 for operation.
Factory default
This function returns all setting values except for the lamp counter to the factory default settings.
Press POINT UP/DOWN button to move a red frame pointer to “Factory default” and then press SET button. The message "Return to Factory default?" is displayed. Move the pointer to [Yes] and then press SET button.
Another confirmation dialog box appears and select [Yes] and then press SET button. Return the projector to Factory default.
40