Canon LV-7565F owner manual Lamp Replacement

APPENDIX

LAMP REPLACEMENT

LAMP REPLACE

When the life of the Projection Lamp of this projector draws to an end,
	TOP CONTROL
the LAMP REPLACE indicator lights yellow. If this indicator lights
yellow, replace the projection lamp with a new one promptly.

This indicator lights yellow when the life of the projection lamp draws to an end. Replace the Projection Lamp with a new one promptly.

		CAUTION
Allow a projector to cool, for at least 45 minutes before	For continued safety, replace with a lamp assembly of
you open Lamp Cover. The inside of a projector can	the same type.
become very hot.	Do not drop a lamp assembly or touch a glass bulb! The
	glass can shatter and may cause injury.

Follow these steps to replace lamp assembly.

1	Turn off a projector and disconnect AC plug. Allow a projector to
	cool for at least 45 minutes.
2	Loosen 2 screws with a screwdriver and open Lamp Cover.
3	Loosen 2 screws with a screwdriver and pull out Lamp Assembly
	by grasping Handle.
4	Replace Lamp Assembly with a new one and tighten 2 screws
	back. Make sure that Lamp Assembly is set properly. Replace
	Lamp Cover and tighten 2 screws.
5	Connect AC Power Cord to a projector and turn it on.
6	Reset Lamp Replace Counter (refer to next page “Lamp Replace
	Counter” section).

NOTE : Do not reset Lamp Replace Counter when Projection Lamp is not replaced.

	LAMP COVER
LAMP	HANDLE
ASSEMBLY

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following information to the dealer.

●	Model No. of your projector	: LV-7565U/LV-7565FU/LV-7565E/LV-7565FE
●	Replacement Lamp Type No.	: LV-LP22
		(610 314 9127)

44