Connecting Cable TV

16-289.fm Page 6 Tuesday, July 20, 1999 10:57 AM

•If you have a combination VHF/ UHF antenna and the antenna uses 300-ohm flat wire, connect the flat wire to the screw terminals on the supplied 300-to-75 ohm

adapter. Then connect the adapter to the TV’s VHF/UHF (75Ω) terminal.

VHF/UHF (75Ω) Terminal

VHF/UHF Antenna

300-to-75 Ohm Adapter

300 Ohm Flat Wire

If you subscribe to a cable TV service, connect the cable company’s 75-ohm coaxial cable directly to the TV’s VHF/ UHF (75Ω) terminal.

If you use a cable box, connect the box’s output to the TV’s VHF/UHF (75Ω) terminal.

From Cable Company

75-Ohm Coaxial Cable

OUTIN

Cable Box

•If you have separate VHF and UHF antennas, use a VHF/UHF combiner (not supplied) to com- bine the VHF and UHF signals. Then connect the combiner’s 75-

ohm connector to the TV’s VHF/ UHF (75Ω) terminal.

VHF Antenna

UHF Antenna

VHF/UHF (75Ω) Terminal

VHF/UHF Combiner

Set the TV to the same channel as the box’s output (Channel 3 or 4) and use the box to select channels.

Note to CATV System Installer: This reminder is provided to call the CATV system installer’s attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical.

You can listen to your TV by connect- ing an earphone to the TV’s EAR- PHONE jack, or by connecting the TV’s AUDIO IN/VIDEO IN jacks to a home audio system.