TechniSat DigiPal 2 For daily use, Switching on and off, Using the programme list, Volume control

Page 54

For daily use

Switching on and off

>Switch on the digital receiver bypressing the On/Standby key, either on the receiver or on the remote control.

>Press this key again to switch the receiver off.

>The receiver is now in standby mode, the display on the receiver shows the time.

Programme selection

Using the programme up/down keys

>Use the programme keys up/down either on the remote control or on the receiver to move up or down one programme slot at a time.

Using the numeric keys

>Use the numeric keys to enter the desired programme number.

For example

 

1

 

for programme slot 1

1,

then 4

for programme slot 14

2,

then 3, then 4

for programme slot 234

When entering programme numbers consisting of several digits, you have approximately 3 seconds after pressing a key to complete the entry.

If you wish to enter a number consisting of only one or two digits, you can speed up the switching procedure by keeping the key depressed a little longer on the last digit.

Using the programme list:

>Press OK.

>You can now use the arrow keys up/down to mark the desired programme.

>Press OK to switch to the marked programme.

>Use the arrow keys up/down to move the marker by one line at a time within the list.

>Use the arrow keys right/left to move the marker around the list one page at a time.

Volume control

>You can regulate the volume of your digital receiver: press the key Volume + to increase the volume, and Volume - to decrease it.

>Press the key Sound on/off to switch the sound on or off (mute).

54

Image 54
Contents DigiPal Contents Page Page Remote Control IllustrationsVCR Page Please read this first Important notes on operationSafety notes When not in useVCR Connection to a television set ConnectionsAntenna Video cassette recorder VCRHi-fi amplifier Getting started initial installationMains power connection Serial interface RSMenu/OSD language Exiting from the installation assistant Menu language SettingsBasic settings Time difference to GMT hoursAntenna feed Remote control codeCountry Stand-by clockTV Scart mode Audio/Video settingsLanguage Audio signal VCR Scart modeOperation Antenna adjustmentSwitching on and off Dolby Digital AC3Using the programme list Navigator Using the Programme up/down keysUsing the numeric keys Programme selectionSelecting a list Calling up blocked programmesInformation box Volume control Dolby Digital AC3 modeSelecting a different language Display time and programme information TV/Radio switchingReturn to last programme selected Additional Programme informationFreeze frame Sleep timerChannel information Video textSub-titles Electronic Programme Guide SFI Downloading SFI dataInterrupting the download Now Table of current programme contents Viewing the Electronic Programme GuideNext SFI Information MoreSFI Functions Marking a programmeSFI Timer programming SFI Programme overviewSFI overview by programme type catego Timer recording Manual timer programmingExiting SFI Page Deleting timer programming Timer overviewChanging timer programming Programming a new timer eventConfiguring the Favourites list Changing the basic programmingCalling up the Navigator Programme List Manager Adding programmes to the Favourites list Remove Programming the electronic programme guide Deleting from the Total listSorting programmes Selecting a channel Please noteStart category SFI ChannelParental controlblocking programmes Changing the receiver PIN codeMode Selecting a programmeProgramme search scan Automatic ScanExpanded Scan Channel scanManual Scan After the scanService settings Activating default factory settingDelete all programmes Copying settings Updating SoftwareSystem configuration Technical termsTechnical data OSDTV Scart BT.653-2 lines 6-22 Trouble-shooting guide Problem Possible cause SolutionPage Page Index AC3Using the programme list Switching on and offProgramme selection Using the programme up/down keys Volume control