>Confirm by pressing the red function key (“Start search”).
The scan will commence. Please note further information displayed on screen.
>Press the red function key again to end the search.
7.4.4 Manual Search
If you are unable to find a specific programme by means of the search methods described under 7.4.1 and 7.4.2, it may be necessary to enter additional
have to contact the programme provider to obtain the information.
To perform a manual search, call up the menu >Search >Manual Search.
>Use the arrow up/down keys in order to mark the line Manual Search.
>Confirm by pressing OK.
The menu >Search>Manual Search. will be displayed.
This menu differs from the Transponder nmenu only in terms of the menu points PCR- PID,
>Proceed as described under Point 7.4.3.
>Then, use the arrow up/down keys to mark the lines
7.4.5 After the scan
You can follow the scan of the transponder on screen while it is in progress. When the scan is completed, the number of transponders found, the total number of programmes found as well as the number of new programmes found will be displayed.
>Press the yellow function key (“Select”) to access the main memory programme list, in order to configure the programme lists.
>Press the green function key to display a table of options.
>Now use the arrow up/down keys to select All, to display all programmes, or All new, to display only newly found programmes.
>You can now proceed as described in Chapter 7.1 in order to distribute the individual programmes to the various user lists.
7.5 Restore default basic programming/ Delete all
You can return to the default LNB settings, programmed at the factory, at any time. You may also, if the programme list is out of date due to changes in the programme providers, delete this completely, in order to carry out a new scan. Please note that after carrying out the Dele- te function you must then run a programme scan, and then copy the desired programmes
from the main memory list into the various user lists.
> Press the Menu key to display the Main Menu.
29