Cutting, sawing and scraping
CAUTION:
•Do not move on the tool forcibly in the direction (e.g. towards either side) of tool application with no cutting edge. It may damage the tool.
013856 |
Put the application tool on the workpiece.
And then move the tool forward so that the application tool movement does not slow down.
NOTE:
•Forcing or excessive pressure on the tool may reduce efficiency.
•Remove sawdust by drawing tool adequately. It increases work efficiency.
•Before cutting operation, it is recommended to preset the orbital stroke rate 3 - 5.
•The round saw is recommended for cutting long straight line.
Sanding
CAUTION:
•Do not reuse a sanding paper used for sanding metal to sand wood.
•Do not use a worn sanding paper or sanding paper without grit.
013857 |
Apply a sanding paper on the workpiece.
NOTE:
•Using a test material sample to try is recommendable to determine a correct orbital stroke rate suitable for your work.
•Use a sanding paper with the same grit until sanding the whole workpiece is completed. Replacing a sanding paper with different grit
sanding paper may not get a fine finish.
Dust extraction attachment (optional accessory)
| 3 | 1 |
5 | 4 |
|
| 2 | |
|
| |
| 6 |
|
| 7 |
|
1.Joint
2.Nozzle band
3.Dust nozzle
4.Dust attachment
5.Felt ring
6.Pad
7.Holder bolt
013858 |
2 |
1 |
3 |
1 |
1.Nozzle band
2.Protrusions
3.Holes
013052
7