Optimus 114 (16-551) owner manual Timer Recording with VCR Plus+, SET UP CHANNEL, then press FF

16-551.fm Page 35 Tuesday, July 20, 1999 5:13 PM

2.For each station, compare the station’s guide channel number with the number you select on the TV or VCR to tune to the station. If the numbers match, cross that station off of the list.

3.If a tape is playing, press STOP.

4.Press MENU to display the main menu.

5.Repeatedly press PLAY or STOP to highlight

SET UP CHANNEL, then press FF.

6.Repeatedly press PLAY or STOP to high- light VCR Plus+ CH SET UP, then press

FF.

The following appears on the TV screen if you selected a cable box or DSS receiver as your input source.

SET UP

CATV CH

--

--

Y

The following appears on the TV screen if you selected an external antenna as your input source.

VCR P l u s + CH SET UP

GU I DE CH			TV CH
			--
	01
	02		--
SELECT :			KEY
SET		: KEY
END		: MENU KEY

7.Press PLAY or STOP to highlight the guide channel you want to set, then press FF. The cursor moves to the right of the guide channel you selected.

8.Repeatedly press PLAY or STOP to select a CATV CH or TV CH number. Then press REW to set the number.

9.Repeat Steps 7 and 8 for each remaining channel number.

If the channel number is not correct, re- peatedly press PLAY or STOP then FF to select the correct number. Then press

PLAY or STOP to change the number or ADD/DLT to delete it.

10.When you finish, press MENU three times to exit.

Timer Recording with VCR Plus+

Most television guides list a 1- to 8-digit num- ber called a PlusCode™ next to many of the listed programs. You can use these PlusCodes to easily program your VCR to record broad- casts.

You can set the VCR to record as many as eight broadcasts, including any timer programs you want to set up (see “Automatic Timer Re- cording” on Page 37).

You can set the VCR to record at any time on a specific day, at the same time each week, or the same time Monday through Friday.

Before you start, be sure you have set the VCR Plus+ guide channels for your area (see “Set- ting the VCR Plus+ Guide Channels” on Page 34).

Note: The VCR can record only one broadcast at a time. If you schedule recording of broad- casts on different channels that start at the same time, the VCR records the lowest timer number. For more information about timer numbers, see “Setting a Timer” on Page 38.

1.Turn on the TV and set it to the same chan- nel as the VCR’s 3 CH. 4 switch.

Note: If you are using a TV/monitor that is connected to the VCR’s R-AUDIO-L/VIDEO OUT jacks, set it to the video mode.

2.Insert a blank cassette, or one that you want to record over, into the VCR. The VCR turns on.

3.Repeatedly press TV/VCR until VCR appears.

35