•If you have not connected the VCR to an antenna, cable box, DSS receiver, or other signal source through the IN FROM ANT. jack, the VCR does not store any channel in memory. Instead, you see:
NO CH FOUND
PLEASE CHECK ANTENNA
CABLE CONNECTION THEN
PUSH VCR CH UP KEY AGAIN
Turning On Auto Clock Set
If you turned off the auto clock set feature and manually set the VCR’s clock, then find that EDS is available in your area, you can turn the auto clock set feature back on. This ensures that the VCR sets itself to the correct time after a power failure of less than 24 hours.
Follow these steps to turn on auto clock set.
1.Press MENU to display the main menu.
2.Repeatedly press PLAY or STOP to high- light SET CLOCK, then press FF. You see:
K
ET
Y
Y
3.If necessary, press PLAY or STOP to high- light AUTO SET, then press FF.
4.Press CH s. The VCR searches for an EDS signal and, if it finds one, automatically sets its clock to the correct time. If the VCR does not find an EDS signal, follow the steps under “Manually Setting the Clock” on Page 16.
Setting the Cable Box
When you change the connections to your VCR (for example, when you subscribe to a ca- ble company’s service), follow these steps to change the antenna system settings.
1.Press MENU to display the main menu.
2.Repeatedly press PLAY or STOP to high- light SET UP CHANNEL, then press FF. You see:
NNEL
M : CATV
SET UP
ET UP
Y
3.Be sure CATV appears next to ANTENNA SYSTEM. If not, repeatedly press PLAY or STOP to select ANTENNA SYSTEM, then press FF to select CATV.
Then repeatedly press PLAY or STOP to highlight CABLE/DSS BOX SET UP and press FF. You see:
X
VCR
TV
BOX
TV
Y
4.If necessary, repeatedly press PLAY or STOP on the remote control to highlight
VCR 
CABLE/DSS BOX 
TV. Then press
FF. You see:
NNEL
M : CATV
SET UP
ET UP
Y
19