When registering cue points using numbers

While holding	down the ADJ button	Y among the	time code	buttons on the front panel, press the
SHIFT button	Y to establish the cue point registration mode.		After setting the duration to be registered
on the bottom panel using the SHIFT button and ADJ button (same operation as the TCG registration
operation), the setting can be registered by pressing the SET button				T.

Bottom panel

T C

0 0 : 0 0 : 0 0 : 0 0

When the SET button is pressed,

the setting is registered.

Deleting registered points

• By pressing the ESCAPE button	7 while holding down the SET button	T, all the LEDs of the buttons
in which cue points have been registered go off, and the registered points are released. The range of
the pointers which are deleted is as follows depending on the setup menu item No.131 (PAGE MODE)
setting.
When MANU has been set:	All the pointers on the current page are deleted.
When AUTO has been set:	All the pointers on all the pages are deleted.

•The search and registration pointers are set as follows depending on the setup menu item No.131 (PAGE MODE) setting.

When MANU has been set:	The pointers automatically return to the top (CUE	¢1) of the same
	page.
When AUTO has been set:	The pointers automatically return to the top (CUE01) of the first page.

•These operations are acknowledged regardless of whether the search point or registration point display mode is established.

•	By pressing the ESCAPE button		7 while holding down the button among the CUE1 to 8 buttons that
	corresponds to the particular point to be		deleted, the button (LED) corresponding to the point
	registered goes off, and the registered point is deleted.
•	This operation is acknowledged only in the registration point display mode.
	(When the search point display mode is established, the registered point is not deleted even when the
	ESCAPE button	7 is pressed.)

By pressing the PREROLL button	Q, prerolling	can be performed for the cue	point	whose LED is
flashing in the search point display mode.
The tape will not be prerolled if the cue point is not registered.
Since the tape is not prerolled even if the PREROLL button		Q is	pressed	in the registration point
display mode, be absolutely sure to check that the search point display mode has been established.

[Aside from the regular preroll time, the time selected by the setup menu item No.011 (CU-ROLL TIME) is valid as the preroll time in this mode.]

– 52 –