Panasonic AJ-HD150FE operating instructions SBC sub code data area, Vaux video auxiliary data area

Setup menus

USER menu

<TIME CODE>		(continued)
	Item		Setting
									Description
No.	Superimposed		No.	Superimposed
	display				display
509	PHASE		0000			OFF		This selects whether to control	the	phase correction of the
	CORR	0001				ON		LTC generated by the TCG.
								0: Phase correction control is not performed.
								1: Phase correction control is performed.
510	TCG CF	0000				OFF		This selects whether the CF flag of the TCG is to ON.
	FLAG	0001				ON		0: CF flag is OFF.
								1: CF flag is ON.
511	DF MODE	0000					DF	This selects the DF/NDF mode for CTL and TCG.
		0001				NDF		0: Drop frame mode.
								1: Non-drop frame mode.
								<Note>
								The drop frame mode takes effect only when LOCAL is
								established or when ENA has	been selected as the setup
								menu item No.001 (LOCAL ENA) setting.
512	TC OUT	0000				V OUT		This is used to switch the phase of the time code, which is
	REF	0001				TC IN		output from the TIME CODE OUT connector, for the external
								LTC input when the TC INT/EXT switch is at the EXT position.
								(In EE mode only)
								0: Time code is synchronized with output video signal.
								1: Time code is synchronized with external time code input.
513	VITC OUT	0000				SBC		This selects the output method	of VITC to be		superimposed
		0001				VAUX		on output video signal.
								0: Time code recorded in SBC region is outputted in playback
								mode.
								1: Time code recorded in	VAUX	region is	outputted in
								playback mode.
								<Note>
								VITC information detected by HD serial input is automatically
								recorded in VAUX region when the picture is recorded.
514	HD EMBD	0000				OFF		This selects whether VITC information is superimposed on HD
	VITC	0001				ON		serial output.
								0: VITC information is not superimposed.
								1: VITC information is superimposed.
515	HD EMBD	0000				OFF		This selects whether LTC information is superimposed on HD
	LTC	0001				ON		serial output.
								0: LTC information is not superimposed.
								1: LTC information is superimposed.

The underline on the setting item denotes the initial setting.

SBC (sub code data) area:

This area is separate from the video and audio data area on the helical track. The time codes, recording dates and times, and other tape control information complying with SMPTE/EBU standards are stored here. As with the conventional LTC (linear time code), the time code can be read even during rewinding or fast forwarding. It can also be read out when the tape has stopped.

VAUX (video auxiliary data) area:

This area is to be found in the video data area on the helical track. The additional information relating to the video data isstored here.

– 83 –