Panasonic AJ-HD150FE operating instructions Interface

Setup menus

USER menu

<INTERFACE>

	Item		Setting
									Description
No.	Superimposed		No.	Superimposed
	display				display
200	PARA RUN		0000					DIS	This selects whether two or more VTRs are to be operated in
			0001				ENA		synchronization.
									0: No operation in synchronization
									1: Operation in synchronization
									<Note>
									When operating two or more VTRs in synchronization, set all
									the VTRs to 0001 (ENA). (See pages 9 and 17.)
201	9P SEL		0000				OFF		This selects whether the 9P connector functions when the
			0001					ON	REMOTE/LOCAL switch has been set to REMOTE.
									0: Do not function
									1: Function
202	ID SEL		0000				OTHER		This selects the ID information which is returned to the
			0001			DVCPRO			controller.
			0002				ORIG		0: 20 25H
									1: The DVCPRO’s original ID (F0 33H) is returned.
									2: The unit’s original ID (A0 50H) is returned.
									<Note>
									The 2(ORIG) setting should only be used when a Panasonic
									controller (AJ-A900 etc, sold separately) is connected.
203	50P SEL		0000				OFF		This selects whether the PARALLEL (50P) connector functions
			0001					ON	when the REMOTE/LOCAL switch has been set to REMOTE.
									0: Does not function
									1: Functions
204	RS232C SEL		0000				OFF		These settings are for selecting whether the RS-232C
			0001					ON	connector is to function when the REMOTE/LOCAL switch is
									set to REMOTE.
									0: Connector does not function.
									1: Connector functions.
205	BAUD RATE	0000			300				These settings are for selecting the RS-232C communication
		0001			600				speed (baud rate).
		0002			1200
		0003			2400
		0004			4800
		0005				9600
206	DATA	0000			7				These settings are for selecting the RS-232C data length.
	LENGTH	0001				8			(Unit: bit)
207	STOP BIT	0000				1			These settings are for selecting the RS-232C stop bit length.
		0001			2				(Unit: bit)
208	PARITY	0000					NON		These settings are for selecting the none, odd or even for the
		0001					ODD		RS-232C parity bit.
		0002					EVEN		0: Parity bit is not used.
									1: An odd number of bits is used for the parity system.
									2: An even number of bits is used for the parity system.
209	RETURN	0000				OFF			These settings are for selecting whether the ACK code is to be
	ACK	0001						ON	returned when a command is received from RS-232C.
									0: ACK code is not returned.
									1: ACK code is returned.
210	50P STBY	0000				OFF/ON			For selecting the method used to detect the STANDBY
	CMD	0001					ON		COMMAND signal input at the PARALLEL (50P) connector.
									0: Each time active signals are detected, the STANDBY ON or
									STANDBY OFF mode is selected alternately.
									1: When active signals are detected in the STANDBY OFF
									mode, the unit is transferred to the STANDBY ON mode.
									Nothing happens if they are detected during an operation in
									the STANDBY ON mode.

The underline on the setting item denotes the initial setting.

– 76 –