Panasonic NV-FJ760 manual Connect the RF coaxial cable to the Aerial Output socket

Connecting the VCR to a Satellite Receiver or Digital Receiver

Satellite receiver here includes a digital receiver.

The connection method differs depending on the type of your satellite receiver.

For details about the connection, also read the satellite receiver’s operating instructions.

If the Satellite Receiver is Equipped with a 21-pin Scart Socket

If your satellite receiver is equipped with a 21-pin Scart socket, use a 21-pin Scart cable to connect the VCR.

For the connection to the TV, refer to pages 10 and 12.

Be sure to keep the VCR, TV and satellite receiver switched off until you have finished all connections.

For your safety, do not connect or handle the equipment with wet hands.

l

Satellite receiver (not supplied)

1 2

To an AC Mains socket	21-pin Scart socket	21-pin Scart cable
	¡If your satellite
		(not supplied)
	receiver has a
	VCR socket,
	connect the cable
	to it.

1Connect a 21-pin Scart cable (not supplied) to the AV2 21-pin Scart socket l on the VCR and to the 21-pin Scart socket on the satellite receiver.

2Connect the satellite receiver’s mains lead to an AC mains socket.

3Set “AV2” to “TIMER” or “EXT” . For details, see page 53.

If the Satellite Receiver Is Not Equipped with a 21-Pin Scart Socket

In case your satellite receiver is not equipped with a 21-pin Scart socket, use the RF coaxial cable to connect it to the VCR.

For the connection to the TV, refer to pages 10 and 12.

Be sure to keep the VCR, TV and satellite receiver switched off until you have finished all connections.

For your safety, do not connect or handle the equipment with wet hands.

Aerial (not supplied)
Satellite receiver (not supplied)	Aerial Input socket	Aerial lead
		(not supplied)
		1
3	Aerial Output
	socket

To an AC mains socket

2

	n		Operations
		RF coaxial cable
		(not supplied)
1	Connect the aerial lead to the Aerial Input socket on the
	satellite receiver.		Advanced
2	Connect the RF coaxial cable to the Aerial Output socket
	on the satellite receiver and to the Aerial Input socket n
	on the VCR.
3	Connect the satellite receiver’s mains lead to an AC
	mains socket.

Hint:

¡The RF output channel of the satellite receiver should be adjusted away from channel 36, which is used by the VCR, e.g. re-adjust to channel 33.

Note:

How to install the satellite receiver

Carefully observe the following points so that you can control the satellite receiver from the VCR.

1Place the satellite receiver on top of the VCR.

2Move the satellite receiver back a few centimetres so that infra-red signals emitted from the top of the VCR’s front panel can be received by the satellite receiver.

	21-pin Scart cable
Satellite receiver	or RF coaxial cable

Infra-red signal transmitter

[

VCR

41