Panasonic AJ-D960EG manual System Setting Description, Video output signal adjustments

Setup (setting) menus

SYSTEM menu

<SYSTEM> (continued)

	Item		Setting
						Description
No.	Superimposed	No.		Superimposed
	display				display
17	SYS H	0000			FULL	This selects the adjustable range for SYSTEM H during when
	RANGE	0001			FINE	the ENCODER REMOTE is connected.
						0: ±8 ∝sec
						1: –2.0 to +2.7 ∝sec
						<Notes>
						• If setting operation is performed, the setting value does not
						return to factory (default) setting.
						• FULL operation results regardless of this item’s setting if
						SYSTEM H is varied using this unit instead of the encoder
						remote controller.
18	SYS H	0000			–3	System phase adjustment:
	OFFSET	0001			–2	0: –13.4 ∝sec
		0002			–1	1: –8.96 ∝sec
						2: –4.52 ∝sec
		0003			0
						3: 0 sec
		0004			1
						4: +4.52 ∝sec
		0005		2
						5: +8.96 ∝sec
		0006		3
						6: +13.4 ∝sec
						<Note>
						Factory settings will remain unchanged even if an attempt is
						made to perform a setting operation.
19	SYS SC/H	0000			REMOTE	This sets whether the system phase is to be adjusted by the
		0001			LOCAL	unit or from the external encoder remote controller.
						0: The system phase is adjusted from the external encoder
						remote controller.
						1: The system phase is adjusted by the unit.
						<Note>
						This setting does not take effect when LOCAL has been
						selected as the SYSTEM menu item No. 10 (ENCODER SEL)
						setting.
30	MENU	0000			OFF	This selects whether the system file lock mode is to be
	LOCK	0001			ON	engaged or released.
						0: The lock is released (file data can be changed).
						1: The lock is engaged (file data cannot be changed).
						<Note>
						Setup menu No. 00 (WFM SEL) can be changed at any time
						regardless of the setting selected for this menu item.

The underline on the setting item denotes the initial setting.

Video output signal adjustments

The video output signal adjustments are made by selecting the SYSTEM menu item No. 10 (ENCODER SEL) and No. 19 (SYS SC/H) settings. A control matrix of the adjustments is shown below.

Setting			Item adjusted
		SYSTEM menu item		VIDEO LEVEL
SYSTEM menu item	SYSTEM menu item		SYSTEM menu item	CHROMA LEVEL
		11: SYS SC
10: ENCODER SEL	19: SYS SC/H		17: SYS H RANGE	BLACK LEVEL
		12: SYS H
				CHROMA PHASE
LOCAL	LOCAL	Unit	Always FULL	Unit
	REMOTE
			regardless of setting
	LOCAL	Unit		External encoder
REMOTE
		External encoder
	REMOTE		FULL/FINE	remote controller
		remote controller

60 (E)