Panasonic AJ-D960EG manual Video Setting Description

Setup menus

USER menu

<Note>

If the optional SDTI inter- face board (model AJ- YAC960P) has not been installed, setup menus No. 650, 652 and 653 will not be displayed.

<VIDEO> (continued)

	Item		Setting
						Description
No.	Superimposed	No.		Superimposed
	display			display
618	INTERPOLATE	0000			OFF	Vertical interpolation is conducted automatically during slow-
		0001			AUTO	motion playback to reduce the vertical movement of the play-
						back pictures. However, this menu item enables the inter-
						polation operation to be forcibly turned off.
						0: Interpolation is forcibly turned off.
						1: Interpolation is automatically turned on during slow-motion
						playback.
620	ESR MODE	0000			OFF	This selects the operation mode for edge subcarrier reduction
		0001			AUTO	(ESR) in the playback circuit.
						0: The mode is forcibly set to OFF.
						1: The mode is automatically set to ON or OFF depending on
						the VTR operation.
621	CCR MODE	0000			OFF	This selects the cross colour processing during playback.
		0001			ON	0: The cross colour is output with no changes made.
						1: The cross colour can be reduced.
						<Note>
						This setup menu is not displayed in the 625 mode.
640	SDI INDEX	0000			OFF	This selects the operation to the video index (CF and WIDE)
	O	0001			ON	for the serial output.
						0: The video index is not added to serial output signal.
						1: CF and WIDE information is added to the serial output
						signal as the video index.
650	SER IN	0000			MANU	For selecting the serial input mode.
	MODE	0001			AUTO	0: The SDI signal or SDTI signal is automatically selected in
						accordance with the serial input signal. The input display
						on the front panel is automatically switched in accordance
						with the input signal.
						1: The same mode is selected as the input mode selected on
						the front panel.
652	SER OUT1	0000			SDI	For selecting the signal to be output to serial output 1.
	SEL	0001			SDTI	0: The SDI signal is output.
						1: The SDTI signal is output.
653	SDTI MODE	0000			1X_R	Selects the VTR and SDTI input/output operation when a
		0001			2X_P	DVCPRO50 or DVCPRO tape has been inserted.
						0: Normal mode is set.
						Recording, playback and SDTI input/output can be
						performed at 1⋅ speed.
						1: 2⋅ transmission mode is set.
						Playback and SDTI output can be performed at 2⋅ speed.
						<Notes>
						• This setup menu’s setting takes effect only when “SDTI” or
						“AUTO” has been selected as the setup menu No. 652 (SER
						OUT1 SEL) setting. If “SDI” has been selected, the tape will
						be recorded and played back at the 1⋅ speed regardless of
						this setup menu’s setting.
						• When “2X_P” has been selected, the tape cannot be played
						back at the 1⋅ speed.
						• If a tape is inserted when “2X_P” has been selected, the
						REC INHIBIT lamp lights and recording operations are pro-
						hibited. In addition, the VV mode will be established at all
						times, and the EE pictures will not be output.
						• When a DV or DVCAM tape has been inserted, it is played
						back at the 1⋅ speed regardless of this setup menu’s setting.

The underline on the setting item denotes the initial setting.

78 (E)