Pelco C2900M-B(1/03 Com ports Terminal, To program the unit through HyperTerminal, Baudrate 19200

The default parameters of the transparent data port agree with the most commonly used settings, as shown in the following table.

Table G. Interface Settings

Configuration	Default Setting	Description
Item
Com ports	Terminal	This port can be set to Terminal mode, which is used
		to program the unit through HyperTerminal.
		Or, it can be set to Transparent, which allows
		control of devices such as a digital video recorder
		(DVR) or pan/tilt/zoom camera, etc. When set to
		Transparent PelcoNet cannot be accessed through
		HyperTerminal.
Baudrate	19200	Select any transmission rate from 300 to 19200 baud.
Data bits	8	Select the number of data bits (7 or 8) per character.
Parity	None	Select the type of parity check (Odd, Even, or None).
Stop bits	1	Select the number of stop bits (1 or 2) per character.
RS232/485	RS232	Select the required protocol for the port.
Halfduplex mode	off	If you choose this RS-485 mode, camera control data
		is transferred automatically to the control port, which
		is a serial interface on the unitÕs rear panel to which
		you can connect a PC. This mode supports flow
		control.
		NOTE: In the ÒonÓ or ÒbufferedÓ mode, transparent
		data is rerouted to the control terminal port; terminal
		functions are provided on the transparent data port.

C2900M-B (1/03) 61