Pelco C2900M-B(1/03 Off, Base Port 25000, Server at this IP address Mail reply None, Group IP

		Table C. Network Settings (Continued)
DHCP	off		Dynamic Host Configuration Protocol. When set to on, the
			network DHCP server automatically assigns your computer
			an IP address. When set to off, you must assign it yourself.
Base Port	25000		Enter a setting to designate which TCP/IP ports PelcoNet
			uses for transmission, video, audio, and control. For
			example, the default setting of 25000 means PelcoNet will
			use TCP ports 25000-25001 and UDP ports 25002-25011
			(12 ports total) for all video and control data.
Mail server	none		Entry is only required if the mail-sending feature is to be
IP address			used. Outgoing e-mail is sent to the mail server (SMTP
			server) at this IP address.
Mail reply	none		Enter a name for the NET104A that lets the device be
address			easily identified. This is similar to the unit identification
			Name field on the General Settings configuration page.
			This field identifies the device from a distance. The name
			helps when there are many PelcoNet units on the network.
			The recipient of the e-mail can identify the e-mailÕs sender
			by this entry.
Multicast	0.0.0.0		This is the Multicast IP Address. (Network hardwareÐ
Group IP			such as switches, hubs, routers, etc.Ðmust support the
			multicasting protocol, ICMP.) This field sets PelcoNet to
			use the multicasting protocol, which allows more efficient
			use of bandwidth. The IP range is 224.0.1.0 through
			238.255.255.255.
Time To Live	1		This setting specifies how many routers an information
(Multicast)			packet can go through before it expires.
Enable	Off		When set to On, this setting lets the PelcoNet unit support
Multilink H.323			five simultaneous live video connections.
Enable	Off		This setting, in conjunction with the Multicast Group IP and
Multicast			Enable Multilink H.323 settings, can allow an unlimited
Streaming			number of live video connections. The Enable Multilink
			H.323 field, as well as this field, must both be set On for
			this to work.
Multicast	60000		This setting designates the TCP/IP port PelcoNet uses for
Video port			video when using the multicasting protocol.

C2900M-B (1/03) 47