Pelco Dx8000 manual Mount the NEW Drive, Inserting the New Drive into the Basket

Page 16

MOUNT THE NEW DRIVE

1.Mount the new drive in the drive basket. Use the drive slot closest to the CD-RW drive. Refer to Figure 12.

a.Make sure the drive is mounted in the basket so that access to the connectors is not blocked.

b.Attach the drive to the basket using the two screws that came with the upgrade kit.

c.Tighten the screws securely but do not over-tighten.

Figure 12. Inserting the New Drive into the Basket

14

C1606M (6/04)

Image 16
Contents DX8000 Page Introduction Parts ListTools Needed Removing Power Cord from Wall Getting ReadyRemoving Power Cord from Unit ESD Protection Prepare Unit for Drive Installation Open the Unit ChassisRemoving Chassis Cover Component Layout DX8000 InteriorMove the Front Cross-Brace Removing Front Cross-BracePlacing Front Cross-Brace Across Rear of Unit Disconnect the Data and Power Cables Removing the IDE Data Cable Removing Hard Drive Power Connection Remove the Drive Mount Basket Removing Hard Drive BasketReplace the Primary Hard Disk Remove the Original DriveMount the NEW Drive Inserting the New Drive into the BasketReplacing Drive Basket SET the Master / Slave Jumper Setting Drive Jumper Reconnect the Data and Power Cables Installing CD-RW and Hard Drive Data Cable Installing Power Connector Reassemble the Unit Replacing Front Cross-BraceReplacing Chassis Cover Restarting Unit Install Software on the New Drive Configure System to Boot from CD/DVDAwardBIOS Setup Utility Main Advanced Power C1606M 6/04 Install Software DX8000 Recovery dialog box appearsC1606M 6/04 C1606M 6/04 AwardBIOS Setup Utility Item Specific Help IDE Hard Drive Initialize the New Drive Opening List of DrivesSelecting Allocation Option Formatting Dialog Box C1606M 6/04 Product Warranty and Return Information ISO9001
Related manuals
Manual 32 pages 20.54 Kb Manual 36 pages 35.01 Kb Manual 10 pages 26.21 Kb Manual 1 pages 21.57 Kb