Pelco Dx8000 manual Restarting Unit

Page 25

3.Reinstall the unit in a rack enclosure if necessary, and reconnect all cables and peripheral equipment that you removed earlier.

4.Plug the power cord back into the power supply and then into the wall.

5.Turn on the power switch and allow the unit to start up and find the new hard disk. This may take several minutes.

6.Proceed to the following sections for instructions on how to initialize the drive for service in the DX8000.

ON/OFF

Figure 20. Restarting Unit

C1606M (6/04)

23

Image 25

Contents DX8000 Page Introduction Parts ListTools Needed Getting Ready Removing Power Cord from WallRemoving Power Cord from Unit ESD Protection Open the Unit Chassis Prepare Unit for Drive InstallationRemoving Chassis Cover DX8000 Interior Component LayoutRemoving Front Cross-Brace Move the Front Cross-BracePlacing Front Cross-Brace Across Rear of Unit Removing the IDE Data Cable Disconnect the Data and Power CablesRemoving Hard Drive Power Connection Removing Hard Drive Basket Remove the Drive Mount BasketRemove the Original Drive Replace the Primary Hard DiskInserting the New Drive into the Basket Mount the NEW DriveReplacing Drive Basket SET the Master / Slave Jumper Setting Drive Jumper Reconnect the Data and Power Cables Installing CD-RW and Hard Drive Data Cable Installing Power Connector Replacing Front Cross-Brace Reassemble the UnitReplacing Chassis Cover Restarting Unit Configure System to Boot from CD/DVD Install Software on the New DriveAwardBIOS Setup Utility Main Advanced Power C1606M 6/04 DX8000 Recovery dialog box appears Install SoftwareC1606M 6/04 C1606M 6/04 AwardBIOS Setup Utility Item Specific Help IDE Hard Drive Opening List of Drives Initialize the New DriveSelecting Allocation Option Formatting Dialog Box C1606M 6/04 Product Warranty and Return Information ISO9001

Related manuals

Manual 32 pages 20.54 Kb

Manual 36 pages 35.01 Kb

Manual 10 pages 26.21 Kb

Manual 1 pages 21.57 Kb