Pelco Dx8000 manual Remove the Drive Mount Basket, Removing Hard Drive Basket

Page 14

Remove the Drive Mount Basket

1.Remove the first hard drive mounting basket:

a.Using a Phillips-head screwdriver, unfasten and save the four screws that attach the drive basket to the chassis. Refer to Figure 10.

b.Gently lift the basket up and out with the drive attached. Be careful not to force the basket free or to disturb other components inside the unit.

Figure 10. Removing Hard Drive Basket

12	C1606M (6/04)

Image 14

Contents DX8000 Page Tools Needed Parts ListIntroduction Removing Power Cord from Wall Getting ReadyRemoving Power Cord from Unit ESD Protection Prepare Unit for Drive Installation Open the Unit ChassisRemoving Chassis Cover Component Layout DX8000 InteriorMove the Front Cross-Brace Removing Front Cross-Brace Placing Front Cross-Brace Across Rear of Unit Disconnect the Data and Power Cables Removing the IDE Data CableRemoving Hard Drive Power Connection Remove the Drive Mount Basket Removing Hard Drive BasketReplace the Primary Hard Disk Remove the Original DriveMount the NEW Drive Inserting the New Drive into the BasketReplacing Drive Basket SET the Master / Slave Jumper Setting Drive Jumper Reconnect the Data and Power Cables Installing CD-RW and Hard Drive Data Cable Installing Power Connector Reassemble the Unit Replacing Front Cross-BraceReplacing Chassis Cover Restarting Unit Install Software on the New Drive Configure System to Boot from CD/DVDAwardBIOS Setup Utility Main Advanced Power C1606M 6/04 Install Software DX8000 Recovery dialog box appearsC1606M 6/04 C1606M 6/04 AwardBIOS Setup Utility Item Specific Help IDE Hard Drive Initialize the New Drive Opening List of DrivesSelecting Allocation Option Formatting Dialog Box C1606M 6/04 Product Warranty and Return Information ISO9001

Related manuals

Manual 32 pages 20.54 Kb

Manual 36 pages 35.01 Kb

Manual 10 pages 26.21 Kb

Manual 1 pages 21.57 Kb