FUNAI ZV457MG9 owner manual Connections Basic, With this setup

Page 19

CONNECTION TO A CABLE / SATELLITE BOX

1)Disconnect the power cords of the devices from the AC outlet.

2)Make the connection as illustrated below.

3)Plug in the power cords of the devices to the AC outlet.

Introduction

e.g.)

rear of this unit


HDMI OUT
		DVD/VCR	DVD			DVD/VCR	OUT		OUT

		DIGITAL	AUDIO	S-VIDEO COMPONENT		S-VIDEO IN ---AUDIO---OUT
		AUDIO OUT	T		VIDEO OUT
		S-VIDEO IN ---AUDIO---OUT			Y	L	LIN
							ANTENNA
			L	OUT	PB	INR	R
			L	OUT	/CB	INR	R
		COAXIAL				IN ---VIDEO---OUT

L	R	PR
		/CR

IN

IN		R		ANTENNA
IN

S-video cable

RCA video cable

or

RCA audio cable

R	L	S-VIDEO
AUDIO OUT VIDEO OUT		S-VIDEO
		OUT

cable/satellite box

Connections Basic

IN ---VIDEO---OUT

RF coaxial

This connection is

cable

for TV loop

RF coaxial

through only

cable

ANT. IN

rear of your TV

RF OUT ANT. IN

satellite

RCA audio

dish

cable

RCA video

RF coaxial

cable

cable

VIDEO IN

R

L

or

AUDIO IN

cable TV company

Supplied cables used in this connection are as follows:

•RF coaxial cable x 1

•RCA audio cable (L/R) x 1

•RCA video cable x 1

Please purchase the rest of the necessary cables at your local store.

Note

•Required cables and connecting methods differ depending on the cable/satellite box. For more information, please contact your cable/satellite provider.

•Instead of using video out jack of this unit, you can also use S-VIDEO OUT jack, COMPONENT VIDEO OUT jack or HDMI OUT jack (no AUDIO OUT jack connection required) (DVD only) for connecting to your TV.

With this setup:

•You can record any unscrambled channel by selecting the channel on the cable/satellite box. Be sure that the cable/satellite box is turned on.

•You cannot record one channel while watching another channel.

Note to CATV system installer

•This reminder is provided to call the cable TV system installer’s attention to Article 820-40 of the National Electrical Code, which provides guidelines for proper grounding - in particular, specifying that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as possible.

EN 17

Setup Recording Playback Editing Function Setup VCR Functions Others

Español

Image 19

Contents ZV457MG9 Playable files Plug in the power cords of the devices to the AC outletYou can play back DVD+RW on most DVD players without Playable discsInsert a disc Place the disc properly. Press OPEN/CLOSE aChannel / or the Number buttons and for digital TV 6Press Stop C to stop recordingDo not Open PrecautionsFCC Warning PrecautionsTo Avoid the Hazards of Electrical Shock and Fire Supplied AccessoriesLocation and Handling Dew Condensation WarningCleaning the disc lens Disc handling Maintenance ServicingCleaning the cabinet Cleaning discsContents Contents Features Symbol Description FeaturesDescription refers to DVD+RW Description refers to DVD-RW Front Panel 21 2019 18 Functional Overview13 12 11 Rear Panel Functional Overview12 11 2625 Remote ControlOpen the cover Insert batteries Close the coverChannel / buttons DVD/VCR DVD mode Confirm button DVD/VCR Analog modeREW E button DVD/VCR DVD mode VCR modeDisplays the following Front Panel DisplayDisplay Message Current status of the unitAntenna Cable Connection Disconnect the power cord of your TV from the AC outletRF Modulator Connection Plug in the power cords of the devices to the AC outletConnections Basic With this setupAvailable on DVD only Method Analog audio Good picture Connection to a TVThis unit RCA video cableCables not included Hdmi Mode and Actual Output SignalsInterlaced Press Hdmi Progressive Actual Output Modes by MediaConnection Dolby Digital SettingConnection to AN Audio System AudioTurn on your TV Setting onBefore YOU Start Finding the Viewing Channel on Your TVHdmi Information Before YOU StartGuide to On-Screen Display / Menu MP3 Tag InformationFile Name Information Title Name InformationFirst, track name will be displayed Main Menu How to Insert a Cassette Tape Switching DVD / VCR ModeHow to Insert a Disc / Cassette Tape How to Insert a DiscSetting on Initial SettingScanning Channel SettingWhen scanning is over, press Setup to exit Auto Channel ScanAdding / Deleting Channels Channel SettingUse K / L to select Manual Channel Preset, then press OK General Setting menu will appearUse the Number buttons to select a channel directly Press Setup to exitSelect the channel number to add or delete Use K / L to select Add or Delete, then press OKPress Setup and turn off the unit Setting the ClockAuto Clock Setting Press Setup to exit Press STANDBY-ON y to turn off the unitDaylight Saving Time Setting the ClockManual Clock Setting Use K / L to select Clock Setting, then press OKSwitching Analog Mode Digital Mode Tuner SettingsChannel Selection Selecting TV Audio Tuner SettingsStereo Selecting TV Audio cont’dSAP secondary audio program DTV Closed Caption Use K / L to select Caption Service, then press OKSelect if you do not want DTV CC. This is the default Service 1 to ServiceClosed Caption Style Use K / L to select User Setting, then press OKUse K / L to select ON, then press Font Style Font SizeEdge Type Edge ColorUnrecordable Discs Recording ModeInformation on DVD Recording Recordable DiscsRecording the DTV Closed Caption Setting for Auto ChapterBefore Recording Make Recording CompatibleFollow the steps to record TV programs Press REC Mode to select a recording modeRefer to Recording Mode on Desired channel to recordPress Stop C Basic Recording & ONE-TOUCH Timer RecordingPress Stop C to exit the title list Press REC I repeatedly until the desired length appearPress Timer Use K / L to select New Program, then press OK Timer RecordingUse K / L to enter the date, then press B Press OK when all items are Entered Timer RecordingPress Timer SET Check the information To stop the timer recording in progressHow to select a channel number for the timer recording Stop C on the remote control is not effectivePriority of Overlapped Settings Hints for Timer RecordingOverwriting in the Middle of the Title Overwriting Unnecessary TitleOverwriting from the Beginning TitleOverwrite recording a Existing title B Existing title C Overwriting Unnecessary TitleHints for Overwriting Overwrite recording a Existing title B After overwritingConnection to an External Device Settings for AN External DeviceRecording to a DVDPress DVD Settings for AN External DeviceRecording from an External Device Press VCRPreparing for dubbing cassette tape to DVD BI-DIRECTIONAL DubbingUse K / L to select Recording, then press OK Use K / L to select Dubbing Mode, then press OKPress Stop C to stop the dubbing BI-DIRECTIONAL DubbingUse K / L to select VCR DVD, then press OK Use K / L to select DVD VCR, then press OKDisc will be protected Setting a Disc to ProtectUse K / L to select Yes, then press OK OFF ON, then press OK. e.g. DVD+RWFinalizing is completed Press Setup Use K / L to select Disc Edit, then press OKFinalizing a Disc Use K / L to select Finalize, then press OKAuto Finalizing Playing the Discs on Other DVD PlayersColor Systems Information on PlaybackPlayable Discs and Files Unplayable DiscsHint for DVD Playback CD Playback Mode menu will appearInformation on Playback PBC playback control for Video CDPress Stop C once to stop playback temporarily Basic PlaybackDirect Playback Press Play B to start playbackUse K / L to select Play, then Basic PlaybackPlayback from the Title List Use K / L to select a desired titleOr track/file, then press OK Playing Back an Audio CD and a CD-RW/-R with MP3 FilesUse K / L to select a desired folder Playback will be paused and sound will be muted Using the Title / Disc MenuPause During playback, press Pause FSkipping TV Commercials During Playback Special PlaybackResume Playback Fast Forward / Fast Reverse PlaybackZoom Special PlaybackStep by Step Playback Slow Forward / Slow Reverse PlaybackMarker Setting Repeat Playback Repeat this step until you program all the desired tracks Random PlaybackProgram Playback Use K / L to select Random Play, then press OKTitle / Chapter Search Using H / GUsing Display SearchTime Search SearchAudio CD Switching Audio Soundtrack Switching SubtitlesFor DVD-video Audio soundtrack will switch Reducing Block Noise Switching Virtual Surround SystemSwitching Camera Angles Selecting the Format of Audio and VideoPress DVD, then press Title Information on Disc EditingGuide to a Title List Editing DiscsUse K / L to select Edit, then Editing DiscsDeleting Titles Press DVD first Press TitleAfter this operation is completed, press Return to exit Editing DiscsPutting Names on Titles Use K / L to select Edit TitleSubmenu will appear Setting Chapter MarksUse K / L to select Add, then press OK Press Return twice to exitEdit Chapter Mark Delete Clearing Chapter MarksTo delete all chapter marks Clearing Chapter Marks cont’dAll chapter marks will be deleted Hiding Chapters Press Return to exit Setting Pictures for ThumbnailsPicture for thumbnail will be set Use K / L to select Yes, then press Dividing a TitleName, then press OK. e.g. DVD+RW When you finish entering a title name, pressPutting Name on Disc You can put a name on the disc and change it from this menuErasing Disc Compatible, then press OK Making Edits CompatibleContents List of SettingsTV-PG TV-G TV-Y7 List of SettingsVCR DVD Use K / L to select a desired item, then press OK SetupsPlayback Use K / L to select Playback, then press OKYes SetupsParental Lock Default OFF Playback cont’dAngle Icon Default on Disc Menu Language Default EnglishAudio Language Default Original Subtitle Language Default OFFSet Selected item DisplayUse K / L to select a desired item On pages 85-86Display cont’d FL Dimmer Default BrightChip To set the rating Change Password Change the current passwordUse the Number Buttons to enter new access password Canadian English RatingRefer to 1 to 2 on this page and set Progressive Scan Default OFFTV Aspect Default 43 Letter Box VideoRGB Range Default Normal When you finish with the setting, press Setup to exitFormat Default RGB Hdmi Audio Default onYour setting in recording will be initialized Reset AllSelect Yes again using K / L , then press OK Reset the setting to defaultTo resume playback 2Select the recording mode using REC ModeRecording mode VCR FunctionsVCR Functions One-touch Timer Recording OTRPress REC I to begin the one-touch timer recording You cannot pause the one-touch timer recordingOther Operations Symptom Remedy TroubleshootingPress OPEN/CLOSE a TroubleshootingOPEN/CLOSE a to take out the disc. The disc canceled during Repairing process MAY not workREC Frequently Asked QuestionsOutput Jacks Disc Error message Cause Solution Language Code Language CodeGlossary Tuner SpecificationsGeneral RecordingCódigos de Región EspañolDiscos Reproducibles Disco GrabableParte trasera de este aparato EspañolPresione REC I para iniciar la grabación Presione STANDBY-ON yBandeja de discos Para seleccionar un modo deDVD Presione Abra la bandeja deDe discos Memo Tel Customer Service1VMN25873