JVC HR-J795EK manual Preset Download

before you start

Check that the VCR is turned off and no cassette is inserted

Load the batteries into the Remote Control

Refer to the Remote Control diagram on pages 6–7

Unless indicated otherwise, use the buttons on the Remote Control

Check that the connection is completed

Be sure to use the fully- wired 21-pin SCART cable

Turn on the TV whose channels have already been stored

O– –:– –

					TV
ENT						TV/VCR	AUDIO		– –:– –
	ER/
		EN			1	2			3
			TR
3	OK			EE					2
			/		4	5			6
					VPS/PDC	DAILY/QTDN. WEEKLY/HEBDO
PR	+				7	8			9
					0000	AUX			4
						0
					START	STOP	DATE		PR
					DEBUT	FIN
						EXPRESS
				1	PROG	?			30 SEC
							ENTER/ENTREE
					MENU			3	OK
						TV PR		+
					T				+
					V
					–				TV
						TV PR		–

TE PR

	ENTE
		R/EN
		TR
ME	3	OK /	EE
NU
	TV PR	+
T			+
V
–			V
			T
	TV PR –

three step quick start 11

FINISH AUTO SETUP

Press 3 OK / and move on to Step 2 to check the results.

oops! If there is a power cut or you accidentally press a button during Auto Setup, turn the VCR off and then on again. Re-perform Auto Setup.

Preset Download

START PRESET DOWNLOAD
Press the obutton. The display panel on the				SAT
front of the VCR will show the word ‘Auto’.				VCR
Press the Aor Bbuttons to select				REVIEW
‘CH – –’ and press	3	OK /	(or E).
what will happen? The VCR is automati-
				SAT
cally setting up the tuner channels by down-				VCR
loading from your TV, clock and the VIDEO				REVIEW
				Preset Download is running:
Plus+ system assigned Guide Program
numbers. During downloading, preset position				don’t touch any buttons

on the display panel increases from “CH1”.

rf and scart connection If the TV set is in its AV mode (see the TV manual), you will see the following information displayed on your TV screen:

T-V LINK	GUIDE PROG SET
PLEASE WAIT	PLEASE WAIT

Your TV screen during Preset

[MENU]: EXIT [MENU]: EXIT Download

SET THE VIDEO CHANNEL TO OFF
When Preset Download has finished, ‘COM-
				SAT
PLETED’ appears on the TV screen. Press oto
				VCR
turn off the VCR. Press and hold down Son				REVIEW
the VCR until you will see the display on the
right. Press PR Button on the Remote Control until the figure reads ‘– –’.
FINISH PRESET DOWNLOAD
Press	3	OK /	and move on to Step 2 to check the results.

oops! If there is a power cut or you accidentally press a button during Preset Download, turn the VCR off and then on again. Re-perform Preset Download.

NOTES

•In areas where no TV station transmits the PDC signal, the VCR cannot setup either the clock or Guide Program numbers.

•On this VCR, the characters available for station names (ID) are A–Z, 0–9, –,

*, + and (space). The names of some downloaded stations may differ from those on your TV.