JVC HR-J758E/EH, HR-DD858E/EH specifications Perform Auto Channel SET, View Confirmation Screen

AUTO SET

PLEASE WAIT

EN47

PERFORM AUTO CHANNEL

SET

– –:– –

1 2 3

2

4 5 6

7 8 9

0 4

6

Press OK or %.

●The Auto Set screen appears, and remains on screen while the recorder searches for

receivable stations.		0	+
As Auto Channel
Set progresses, the		[MENU] : EXIT
"	" mark on the
screen moves from		Beginning
left to right.

Wait until the screen as shown in step

+ +

End

7appears.

1

ENU

3 OK

IMPORTANT

●In certain reception conditions, station names may not be stored correctly, and auto Guide Program Number Set may not work properly. If the Guide Program numbers are not set properly, when you timer-record a TV programme using SHOWVIEW, the recorder will record a TV programme of a different station. When programming the timer using SHOWVIEW, be sure to check whether the channel position on which your recorder receives the broadcasting station you wish to record is selected (☞ pg. 26, "SHOWVIEW Timer Programming").

●Your video recorder memorizes all detected stations even if reception of some of them is poor. In these cases picture quality may be poor. To delete those stations with an unacceptable picture ☞ "Delete A Channel" on page 49.

NOTES:

●Fine tuning is performed automatically during Auto Channel Set. If you want to perform it manually, refer to page 52.

●If you perform Auto Channel Set when the aerial cable is not connected properly, "SCAN COMPLETED -NO SIGNAL-" appears on the screen in step 7. When this happens, make sure of the aerial connection and press OK; Auto Channel Set

will take place again.

7

8

VIEW CONFIRMATION SCREEN

After "SCAN COMPLETED"		PR	CH	ID	PR	CH	ID
is displayed on the screen		01	25	ARD	08	C26	E-SP
	02		C08	SKY1	09	55 WEST
for about 5 seconds, the
	03		10	ZDF	10	C24	SAT1
Confirmation screen	04		C65	RAI1	11	C23	OSF
looking like the one to the	05		C31	BBC1	12		– –Ê – –
	06		C32	BBC2	13		– –Ê – –
right appears. The stations	07		C33	3SAT	14		– –Ê – –
your recorder located	[5°°°]
	=			: EDIT
appear on a Confirmation
		= [X] : DELETE
screen — channel		[MENU] : EXIT
positions (PR), channels				C: Cable
(CH) and station names

(ID – ☞ pg. 51). The blueback screen and the programme currently being broadcast by the blinking station appear alternately for 8 seconds each.

To view the next page, use the %Þ% % button on the remote control.

●The stations located in the selected country appear at the top of the list.

●The Guide Program numbers will also be set automatically during Auto Channel Set.

RETURN TO NORMAL SCREEN

Press MENU.

●Using the Confirmation screen, you can skip or add channel positions, enter station names and perform other operations. Refer to pages 48 – 52 for the procedures.

●Depending on reception conditions, the stations may not be stored in order, and the station names may not be stored correctly.

●For information on scrambled broadcasts, refer to page 49.