JVC HR-DD858E, HR-J758EH Basic Playback, Load a Cassette, Point, Start Playback, Stop Playback

Page 11

PLAYBACK

EN11

Basic

Playback

Turn on the TV and select the VIDEO channel (or AV mode).

LAY

	STOP/EJECT	SHUTTLE
	STOP/EJECT	(TIME SCAN)
		(TIME SCAN)

LAY 1

FF

REW

3

STOP

The easiest, most basic operation possible with your video recorder is tape playback. Already-recorded signals on a video tape are read by your video recorder and displayed on your TV just like a TV programme.

1		LOAD A CASSETTE
	Make sure the window side is up, the rear label side is
		facing you and the arrow on the front of the cassette is
		point toward the recorder. Don’t apply too much
		pressure when inserting.

		● The recorder power comes on automatically and the
		counter is reset to 0:00:00.
		● If the record safety tab has been removed, playback
		begins automatically.

		FIND PROGRAMME START
2		POINT
	If the tape is advanced past the start point, press REW or
		turn the (TIME SCAN) SHUTTLE ring to the left.
		To go forward, press FF or turn the (TIME SCAN)
		SHUTTLE ring to the right.

		● The HR-J758E/EH have a standard SHUTTLE ring and
		the HR-DD858E/EH have a TIME SCAN SHUTTLE
		ring.

3		START PLAYBACK
	Press PLAY. “BEST” appears blinking in the recorder's
		display panel during automatic tracking. (☞ pg. 24)
4		STOP PLAYBACK
	Press STOP on the remote or STOP/EJECT on the
		recorder’s front panel. Then press STOP/EJECT to
		remove the cassette.

Usable cassettes

Tape Position Indicator

The tape position indicator appears on screen when, from the Stop mode, you press FF, REW or perform an Index Search. The position of “5” in relation to “0”

(beginning) or “+” (end) 0 + shows you where you are

on the tape.

”O.S.D.” (☞ pg. 8) must

be set to “ON”, or the Beginning indicator will not appear.

3

+ +

1:23:45 REMAIN 2:35

End

● Compact VHS camcorder recordings can be played on

this video recorder. Simply place the recorded cassette

into a VHS Cassette Adapter and it can be used just like

any full-sized VHS cassette.

● This video recorder can record on regular VHS and

Super VHS cassettes. However, it will record and play

back regular VHS signals only. It is not possible to play

NOTE:

Depending on the type of tape used, there may be times when the indication is not correct.

back a recorded Super VHS tape.

Image 11

Contents HR-DD858E/EH HR-J758E/EH Do not place the recorder Safety PrecautionsFor Italy Connect Recorder to Mains Check ContentsBasic Connections Situate RecorderInternational Telephone Country Code Auto Set UpIf you are referring to the front display panel If you are referring to the on-screen displayYour TV to the Video Channel. Refer to Language CodeVia an RF cable only RF connection Video ChannelJust Clock on If both auto channel set and auto clock set have failedLanguage for the on-screen display Just ClockLanguage On-Screen Displays Access Main Menu ScreenAccess Mode SET Screen ENABLE/DISABLE ON-SCREEN DisplayOK or % Power Save ModeSelect Power Save Mode Appears only with HR-DD858E and HR DD858EH Colour System SetAbout Ntsc Playback OK or%Start Playback Basic PlaybackLoad a Cassette PointPause During Playback Playback FeaturesActivate HIGH-SPEED Search Slow Motion For HR-J758E/EH High-Speed Turbo Search For HR-J758E/EHStill Picture/Frame-By-Frame Playback For HR-J758E/EH Manually Adjust TrackingActivate 3R Picture Override Automatic TrackingActivate Instant Review Skip Over UnwantedSections During Playback Activate SpatializerSpatializer Soundtrack SelectionRepeat Playback Press Pause Press TV Prog + or so that the vibration stops Audio signal during TimeScanTimeScan Variable-Speed Search HR-DD858E/EH onlyHR-DD858EHR-DD858EH TimeScanTimeScan Audio Speed SP Speed LP Audio outputBasic Recording Recording Features Type of Broadcast On-screen Display Being Received Receiving Stereo Bilingual ProgrammesTo Record Stereo And Bilingual Programmes A2 Hi-Fi Audio Recording Level Control HR-DD858E/EH only Adjust AudioPreparation Select B.E.S.T. ModeS.T. Picture System During B.E.S.T RecordingPlayback Or press Record on the recorderTimer Programming Satellite Tuner Users Timer WarningTime Express Timer ProgrammingStart Time Enter Programme StopVPS/PDC Recording SET VPS/PDC ModeTimer Mode Engage RECORDER’STime you press Check, Cancel And Replace ProgrammesPress Press Again to check More information. EachFor Example Auto SP→LP TimerAuto Timer Before performing the following steps Prog REC ModeAutomatic Satellite Programme Recording RE-SUPPLY Power Remote Control FunctionsRemove Power Supply SET Remote Control CodeTV Prog + TV/VCR, TV +/- VolumeSET TV Brand Code Operate TVSatellite Tuner Brand Code Satellite Tuner Multi-Brand Remote ControlOperate Satellite Tuner Before you startStart Source Player SET Recording DECK’S Input ModeEdit To Or From Another Video Recorder Make ConnectionsAV2 Select Setting Start Recorder SET RECORDER’S Input ModeEdit From a Camcorder Start CamcorderStart Dubbing SET Input ModeLocate Start Point Engage Audio DubbingProg Reset the CounterInsert Editing Locate END PointEND Insert Editing Engage Insert EditingStart Editing Back of Recorder Connection To Satellite TunerSatellite Tuner Unit SET Tuner Connecting Using a DecoderSelect Input Mode Connect DecoderAUX in or Tape Monitor Connecting Using a Stereo SystemSET Video Channel Access Video Channel SET ModeExit Video Channel SET Mode Video Channel SetAuto Channel Set Tuner SetView Confirmation Screen Perform Auto Channel SETStoring Channels Manually Enter NEW Channel InformationChange Station Channel Position When Receiving a Scrambled BroadcastDelete a Channel Select NEW Station Access ManualSwitch Stations Channel SET ScreenStation Name TV Station And ID ListPress OK twice. The Manual Channel Set screen appears Perform TuningFine-Tuning Channels Already Stored Select Channel to FINE-TUNEGuide Program Number Set Showview SetupNumber Enter Receiving Channel Position NumberSET Date and Time Access Initial SET ScreenAccess Clock SET Screen Clock SetStart Clock Operation SET Just ClockSET Clock Data Source Channel Position If you’re using the RF OUT connec- tion No power is applied to the recorderRemote control wont function Mains power cord is discon- nectedTimer Recording Ä remain lit on the display panel. Is there Problem? EN Questions and AnswersIndex HR-DD858E/EH only EN IndexRemote Control Frequency synthesized tuner Maximum recording timeIN/OUT x 1, IN/DECODER x Memo For More Information see INSTRUCTIONS/P4 Ex. Francais is selected for BelgiumInternational Telephone Language Code