18 EN | INITIAL SETTINGS (cont.) |
5 5
67
VCR TV CABLE/DBS
1 2 3
4 5 6 7
7 8 9
0
6
7
5 |
67
Select cable box output channel
Your selection depends on how your cable box is connected to your VCR.
If your cable box is connected to your VCR’s ANTENNA IN terminal on the rear
Press CH 5° on the front panel or %Þ on the Remote until the channel number representing the cable box’s output (CH2 – CH9) appears on the screen.
If your cable box is connected to your VCR’s AUDIO/VIDEO IN connectors on the front panel Press CH 5° on the front panel or %Þ on the Remote until “ON
If your cable box is connected to your VCR’s AUDIO/VIDEO IN connectors on the rear panel
Press CH 5° on the front panel or %Þ on the Remote until “ON
If you do not use a cable box
Press CH 5° on the front panel or %Þ on the Remote until “OFF” appears on the screen.
Access Cable Box Brand Set screen
Press OK.
Enter cable box brand
On the Remote ONLY: Press the appropriate Number keys to enter the brand code from the list shown to the right, then press OK.
If the cable box’s channel changes to 9, setting is complete Press OK and “CABLE BOX CONTROL IS
ON” appears on the screen for about 5 seconds, then it
returns to the normal screen.
If the cable box’s channel does not change to 9
1Press %Þ (or CH 5° on the front panel) to
move the highlight bar (arrow) to “NO”.
2Press OK.
3Repeat step 7 until the cable box’s channel
changes to 9 by entering another code.
4If the channel does not change after going through all the code numbers listed for your model of cable box, then try all the other numbers.