JVC HR-S7900U 20 EN, Enter DBS Receiver’s brand, AccessPress OKDBS. Receiver Brand Set screen

DBS RECEIVER BRAND SET

51

DID YOUR DBS RECEIVER CHANGE TO CHANNEL 100? =YES

NO

PRESS (5,°), THEN (OK)

PRESS (MENU) TO END

20 EN INITIAL SETTINGS (cont.)

1 2 3

4 5 6 2 7

7 8 9

0 4

1

67

6AccessPress OKDBS. Receiver Brand Set screen

7Enter DBS Receiver’s brand

Press the appropriate	DBS RECEIVER BRAND SET
Number keys to enter
the brand code from the			4 0
following list, then
press OK.
The program currently	PRESS NUMBER KEY (0–9)
	THEN (OK) TO TEST
received through the
	PRESS (MENU) TO END
DBS receiver appears
for about 10 seconds.
BRAND			CODE
JVC (DISH Network)		51
ECHOSTAR (DISH Network)		51
PRIMESTAR		50
SONY (DSS)		41
RCA (DSS)		40

●If the DBS receiver’s channel changes to the channel listed below for your brand, setting is complete

JVC = 100 ECHOSTAR = 100 PRIMESTAR = 55 SONY = 205 RCA = 205

Press OK and “DBS

RECEIVER CONTROL IS ON” appears on the screen for about 5 seconds, then it returns to the normal screen.

●If the DBS receiver’s

channel does not change as shown above

1Press SHUTTLE PLUS %Þ to move the highlight bar (arrow) to “NO”.

2Press OK.

3Re-enter the correct code.

NOTES:

●The Controller may not work with all types of DBS receiver.

●If your DBS receiver does not respond to the code, you cannot use the Controller to change satellite channels. In this case, make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording.

●The VCR can only change the satellite channel through the Controller during timer recording.

●If your DBS receiver cannot be operated with a remote control (because it has no remote sensor), you cannot use the Controller to change its channels. Make sure to leave the DBS receiver turned on and tuned to the proper channel before the scheduled start time of timer recording.

●For customers in U.S.A.: If you are unable to set the Controller, contact JVC toll free at 1-800-537-5722.