JVC HR-S7900U manual Express Timer Programing, 34 EN

34 EN TIMER RECORDING (cont.)

Express Timer Programing

Turn on the VCR and the TV, and select the VCR channel 3 or 4 (or AV mode) on the TV.

You can directly program the VCR’s timer to record up to 8 programmes, as far as a year in advance. Remember, the clock must be set before you can program the timer (☞pg. 8 or 10).

1 Load a cassette

Make sure the record safety tab is intact. If not, cover the hole with adhesive tape, then load it into the VCR.

●The VCR turns on, and the counter is reset, automatically.

2Access PlusCode No. screen

Press PROG..

1

4

DAILY

7

POWER

2 3

2

5	6
8	9	WEEKLY

0 40

3Access Program screen

Press START +/– once.	PROGRAM 1
(If no program is stored,	START		STOP
“PROGRAM 1”
	– –:– –AM	=	– –:– –AM
appears.)	DATE		CH
	– –/– –/– –		– – –	SP

PRESS (+/–, SP/EP, 8=DAILY,

9=WEEKLY), THEN (0K) PRESS (PROG.) TO END

34
5
29	1

7

6 8

4Set program start time

Press START +/– repeatedly to enter the time you want recording to start.

● Press and hold START

+/– to increase the

time in 30-minute

PROGRAM 1

START		STOP
8:00 AM	=	– –:– –AM
DATE		CH
– –/– –/– –		– – –	SP

PRESS (+/–, SP/EP, 8=DAILY,

9=WEEKLY), THEN (0K) PRESS (PROG.) TO END

9

intervals.

5 Set program stop time

Press STOP +/– repeatedly to enter the time you want recording to stop.

●Press and hold STOP +/– to increase the time in 30-minute intervals.

6 Set program date

Press DATE +/– . (The current date is displayed on the screen. The date you enter appears in its place.)

7Set channel number

Press CH +/– .

●If you are using a DBS receiver, see “ATTENTION FOR DBS RECEIVER USERS” on next page.

● Holding down CH +/– rapidly changes the channel numbers.